M2 Antenna Systems 2M8WL Assembly Manual

Summary of 2M8WL

  • Page 1

    M2 antenna systems, inc. 4402 n. Selland ave. Fresno, ca 93722 tel: (559) 432-8873 fax: (559) 432-3059 web: www.M2inc.Com ©2009 m2 antenna systems incoporated 5/8/09 rev.00 model ......................................... 2m8wl frequency range ....................... 144 to 144.6 mhz *gain .............

  • Page 2

    Tools required: screwdriver, 11/32 wrench, socket or spintite, a 7/16" and 1/2" wrench or socket, tape measure. Please review these instructions and the 2m8wlhd dimension sheet before assembly. 1. Boom assembly refer to the 2m8wlhd dimension sheet as a guide. Note the front and rear locations of the...

  • Page 4

    6. Balun installation before installing the balun, thread a 3/8” seal nut all the way onto both connectors, with the black neoprene face of the nuts facing out. Attach balun to the block and tighten the connectors gently using a 7/16" end wrench. Once the connectors are tight, back the seal nuts out...

  • Page 5

    Turnbuckle l-bracket to the vertical riser or to your mast. The riser will enable you to install the antenna at the very top of your mast, should you require it. It also allows the boom to be straight in two dimensions. Make sure that you have determined that top mast mounting is safe for your syste...

  • Page 6

    Of gain. B. To optimize the performance from this high quality antenna, always use high quality coax and connectors, as old, corroded, or poor quality materials are common sources of performance losses. C. If possible, test the antenna, connectors and feedline before installing to your mast or tower...

  • Page 7

    2m8wlhd parts list 1-10-00 rev. 7-11-00 description qty boom section, 2.5 x .125 x 95” sbe ................... 1 boom section, 2.5 x .125 x 95” soe .................. 2 boom section, 2 x .065 x 95” soe ..................... 2 boom section, 2 x .065 x 48” soe ..................... 2 boom section, 1-1...