M2 antenna systems, inc. 4402 n. Selland ave. Fresno, ca 93722 tel: (559) 432-8873 fax: (559) 432-3059 web: www.M2inc.Com ©2015 m2 antenna systems incoporated 05/27/15 rev.01 model ......................................... 2mcp22 frequency range ....................... 144 to 148 mhz * gain ...........
Tool required for assembly: screwdriver, 11/32 nut driver or wrench, 7/16” and1/2” end wrenches, pliers, measuring tape. 1. Start by laying out the boom sections, noting hole positions and matching to the dimension sheet. Use 8-32 x 1-1/2” screws and locknuts to join 1” to 1-1/4” sections; 1-3/4” sc...
9. Installation of the vertical driven element block determines the circularity of this antenna. The orientation of the block for rhc - right hand circularity, is shown on the dimension sheet and drawing. Viewed from the rear of the boom (rearmost reflector horizontal), the vertical driven element b...
14. To add the support, install a 2" u-bolt into the 1-1/2” x 4” turnbuckle plate and attach the turnbuckles. Temporarily install the turnbuckle u-bolt studs into the top set of u-bolt holes in the boom to mast plate and loosely secure with a couple of 5/16” nuts. This "locks" the alignment of the t...
2mcp22 dimension sheet.
2mcp22 assembly details.
Description qty #1 boom section, 1 x .058 x 41.5” .................... 1 #2 boom section, 1-1/4 x .058 x 60” soe ........ 1 #3 boom section, 1-1/2 x .058 x 60” sbe ....... 1 #4 boom section, 1-1/4 x .058 x 60” soe ........ 1 #5 boom section, 1 x .058 x 13” ........................ 1 elements, 3/16 r...