M2 Antenna Systems 440-6SS Assembly Manual

Summary of 440-6SS

  • Page 1

    M2 antenna systems, inc. 4402 n. Selland ave. Fresno, ca 93722 tel: (559) 432-8873 fax: (559) 432-3059 web: www.M2inc.Com ©2015 m2 antenna systems incoporated 05/28/15 rev.01 model ......................................... 440-6ss frequency range ....................... 420 to 450 mhz *gain ...........

  • Page 2: 440-6Ss Assembly Manual

    Tools handy for assembly process: phillips head screwdriver, 5/16”,11/32” spin-tight or socket, 7/16” end wrenches / sockets, measuring tape. 1. This antenna uses a one-piece boom that will be rear mounted. 2. Lay out the elements by length and position as shown on the dimension sheet. Start with th...

  • Page 3: 440-6Ss Assembly Manual

    11. Install the two halves of the shorting bar onto the gamma tube and the driven element below. Refer to the dimension sheet for proper location of the shorting bar. Tighten the shorting bar in place using a single 8-32 x 7/8” screw and lock nut. 12. Now slide the 3/8” x 3/8” vinyl cap over the gam...

  • Page 4: 440-6Ss Assembly Details

    440-6ss assembly details.

  • Page 5: 440-6Ss Dimension Sheet

    440-6ss dimension sheet.

  • Page 6: 440-6Ss Parts & Hardware

    Description ................................ Qty boom section, 1 x .058 x 36” ........................................... 1 elements, 3/16 rod x see dim sheet ........................... 6 gamma connector block assembly ......................... 1 gamma rod, 3/16 x 2.0 alum rod ........................