1. DL manuals
  2. M2 Antenna Systems
  3. Antenna
  4. 6M-3SS
  5. Assembly Manual

M2 Antenna Systems 6M-3SS Assembly Manual

Summary of 6M-3SS

  • Page 1

    M2 antenna systems, inc. 4402 n. Selland ave. Fresno, ca 93722 tel: (559) 432-8873 fax: (559) 432-3059 web: www.M2inc.Com ©2015 m2 antenna systems incoporated 02/27/15 rev.05 model ………………………..6m-3ss frequency range ................ 50.0 to 54.0 mhz tunable *gain ................................... 8...

  • Page 2: Tuning Chart

    Reflector exposed tip length 41 3/8” 40 3/8” 39 1/4” 38 3/16” driven element exposed tip length gamma side 38 1/2” 37 3/4” 36 1/4” 35” driven element exposed tip length non gamma side 38 1/2” 39 1/4” 37 1/2” 36” director # 1 exposed tip length 35 3/8” 34 1/2” 33 7/16” 32 7/16” gamma tube to gamma fe...

  • Page 3: 6M-3Ss Assembly Manual

    Tools handy for assembly process: phillips head screwdriver,11/32” nut driver or socket, 7/16” end wrenches / sockets, measuring tape. *we have supplied a small container of zinc paste with the hardware. It is best to apply a small amount of this zinc paste to each aluminum to aluminum connection to...

  • Page 4: 6M-3Ss Assembly Manual

    12. Install the two halves of the shorting bar onto the gamma tube and the driven element below. Refer to the tuning chart for proper location of the shorting bar. Tighten the shorting bar in place using a single 8-32 x 7/8” screw and lock nut. 13. Now slide the 3/8” x 3/8” vinyl cap over the gamma ...

  • Page 5: 6M-3Ss Dimension Sheet

    “a” dim “a” dim your choice————— your choice————— your choice————— your choice————— “c” dim “b” dim “d” dim “d” dim your choice————— your choice————— 2” u-bolt & unicradle hole patern used for vertical polarity compression clamp spacing 0 1” 28 1/16” 69” the gamma connector block mounts in the hole ...

  • Page 6: 6M-3Ss Assembly Details

    1/2” x 36” 6m-3ss assembly details.

  • Page 7: 6M-3Ss Parts & Hardware

    Description…………………………………………………..Qty boom section, 1 x .058 x 36” soe .................................. 1 boom section, 1 x .058 x 37” ........................................... 1 element section, 1/2 x .049 x 36” .................................. 3 elements, 3/8 x .049 x see dim sheet ..............