M2 Antenna Systems 902-14WLC Assembly Manual

Summary of 902-14WLC

  • Page 1

    M2 antenna systems, inc. 4402 n. Selland ave. Fresno, ca 93722 tel: (559) 432-8873 fax: (559) 432-3059 web: www.M2inc.Com ©2015 m2 antenna systems incoporated 05/28/15 rev.00 model ......................................... 902-14wlc frequency range ....................... 880 to 915 mhz *gain .........

  • Page 2: 902-14Wlc Assembly Manual

    1. Assemble the boom sections using the dimension sheet as a guide for lengths, placement and hardware. 2. Mount the folded dipole mounting block to the small hole about 2-1/4" from the rear of the boom. Orient with the feed connector facing to the front. Secure the block with an 8-32 x 1- 1/4" scre...

  • Page 3: 902-14Wlc Assembly Manual

    8. Attach the feedline and route forward to the mast. Secure at regular intervals with cable ties. If using hardline, provide support near the feed connector to relieve any stress on the dipole block mounting screw and connector. 9. General comments. It is always a good idea to check out the antenna...

  • Page 4: 902-14Wlc Dimension Sheet

    902-14wlc dimension sheet.

  • Page 5: 902-14Wlc Element Layout

    902-14wlc element layout.

  • Page 6: 902-14Wlc Parts & Hardware

    Description qty boom section, 1 x .058 x 60” str .......................................... 1 boom section, 1 x .058 x 57” str .......................................... 1 boom section, 1-1/4 x .058 x 60" sbe .................................... 1 boom section, 3/4 x .049 x 17" str ....................