Summary of PRO
Page 1
The m3d pro 3d printer user manual.
Page 2
Specifications lower build volume: 177.8mm x 177.8mm x 152.4mm upper build volume: 152.4mm x 137.16mm x 33.02mm layer resolution/layer thickness (vertical resolution): 25 to 350 microns filament diameter: 1.75 mm, accepts 3rd party filaments nozzle diameter: 0.40 mm (other sizes available from m3d s...
Page 3: 1.0 Unboxing The
1.0 unboxing the pro the unboxing should be performed carefully to avoid damage to the unit. Remove power supply. Flip box over gently and let the m3d pro slowly slip out of the box onto a flat surface. Do not let the printer fall out of the box for any reason. Once the pro is completely free of the...
Page 4: 2.0 Downloading M3D Software
2.0 downloading m3d software 1. Please visit http://www.Printm3d.Com/downloads to download your operating system specific m3d software. Download the m3d software to a known location, like your desktop. Run the installer and continue through all windows and prompts. 2. Run the m3d software after ...
Page 5
*note factory filament * there may be factory filament installed externally, let the printer extrude this first and then insert your filament of choice. Figure. Showing the filament path taken when installing internal filament, the path begins underneath the print bed through the black filament tube...
Page 6: 5.0 The First Print!
5.0 the first print! 1. Calibrate often a successful first print layer leads to a successful print! To be sure your printer is ready for its first print, select the gear icon to open the printer settings. Then go to the calibration section where you can select advanced calibration. Now select the re...
Page 7: 6.0 Troubleshooting
6.0 troubleshooting 7.0 print settings what is print quality? Print quality refers to the height of a layer. With higher quality prints you will have smaller layer heights and longer print times. What is fill density? Fill density of a print is the amount of filament printed inside the model (the pa...
Page 8: Safety
Safety safety and warnings: choking hazard - the m3d pro 3d printer and its consumables may include small parts that may constitute a choking hazard; additionally, these products may be used to manufacture objects that may themselves constitute a choking hazard. The m3d pro 3d printer is not a toy; ...
Page 9: Legal Conditions
Legal conditions m3d end user agreement: this agreement between m3d llc (a company incorporated under the laws of the state of maryland in the united states), and you, the end-user, which describes important disclaimers, indemnity, safety instructions, software information, and limited warranty info...
Page 10
Www.Printm3d.Com "m3d", 3d ink, and print anything" are registered trademarks of m3d llc in fulton, md.