MAAX Spas California Cooperage 2006 Owner's Manual - page 16
Temperature
The maximum set temperature is 104°F
(40°C) and the minimum set temperature is 80°F
(27°C). The current water temperature or, if the pump
has not been running, two dashes will show on the dis-
play. If dashes are displayed, you must first start the
pump by pressing the JETS 1 pad. Wait until the
water temperature is displayed (approximately 2 min-
utes).
The set temperature of your spa may easily
be increased or decreased at any time using the TEMP
pad. Look at the LED display. Either the actual tem-
perature or 2 dashes will be displayed. Press the
TEMP pad; the set temperature will be displayed in
the LED window. The next touch of TEMP will
change the set temperature either up or down 1°F. If
you want to increase the temperature and the display
indicates the temperature was increased by 1°F, con-
tinue to press the TEMP pad until the desired set tem-
perature is reached.
If you want to decrease the set temperature, and the
LED indicates that the temperature is increasing,
STOP. Wait a few seconds until the actual temperature
is displayed. Then press the TEMP pad again. The
set temperature will be displayed. Press it again and
the set temperature will decrease by 1°F. Continue
pressing the TEMP pad until the desired set tempera-
ture is reached.
If the spa is set in Standard mode or in a filtration
cycle, increasing the set temperature may result in
activating the heater. Decreasing the set temperature
will turn the heater off. When the heater is operating,
the LED below the TEMP icon will be lit
Note: 240-Volt spas that are wired with the 30 Amp
option will not heat when Pump #1 is on in high speed,
or when Pump #2 is operating.
JETS 1
Touch the JETS 1 pad to activate the primary
filtration pump. The sequence of the jet action is:
1 touch = Low jets
2 touches = High jets
3 touches = Off
JETS 2
Touch the JETS 2 pad to activate the therapy
pump. The sequence of jet action is:
1 touch = High
2 touches = Off
The low speed operation of Pump 1 is timed
to automatically turn off after four hours of operation.
The high speed operation of Pumps 1 and 2 is timed to
automatically turn off after 30 minutes of operation.
Note: Pump 1 will automatically operate in low speed
whenever the spa calls for a filtration cycle or heat.
When this automatic activation occurs, the low speed
of Pump 1 cannot be turned off; however, all other
control functions can be activated.
Light
Touch the LIGHT pad to turn the internal spa light
on and off. The spa light will automatically turn off
after 60 minutes of operation.
Standard/ Economy/Sleep Modes
Your spa can be switched among Standard,
Economy, and Sleep Modes by touching the TEMP
pad and then the LIGHT pad. If your spa is in the
Standard mode, the low speed of Pump 1 and the
heater will come on automatically to maintain the set
temperature of the water. If your spa is set in the
Economy mode, the heater will operate ONLY during
the filtration cycles. The pump will circulate for
approximately two minutes several times throughout
the day to sample water temperature.
If your spa is set in the Sleep mode, the heater and
pump will operate either during a filtration cycle or,
when the heater housing temperature drops below
45°F, from the set temperature. The spa will heat to
within 20°F/10°C of the set temperature only during
filter cycles.
The selected mode will be displayed in the LED
window of the control panel. When in Standard
mode, the letters ST are displayed, followed by the
water temperature. When in Economy mode, the let-
ters EC are displayed alternately with the water tem-
perature. When in Sleep mode, the letters SL are dis-
played alternately with the water temperature.
11