Summary of RCKH315EH
Page 1
New moffat dryer rckh315eh 07-man-dr-01.
Page 2: Important Safety Notice
2 important safety notice the information in this presentation is intended for use by individuals possessing adequate backgrounds of electrical, electronic, and mechanical experience. Any attempt to repair a major appliance may result in personal injury and property damage. The manufacturer or selle...
Page 3
3 features • 3.6 cubic foot capacity • sensor drying • automatic end of program signal • stainless steel drum • care + • 4 dryness levels • reverse tumble action - at the end of the drying cycle, during the cooling cycle, the motor will stop and restart in the opposite direction. With this feature, ...
Page 4
4 how to remove the top remove the two screws that hold the top to the rear and pull toward you to disengage. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 5
5 how to access the motor remove the right side panel. A) remove the four screws under the dryer for side panel. (figure 1) b) with the dryer upright remove the top panel. C) remove the three screws holding the control panel and remove the control. (figure 2) d) this will expose two screws on each s...
Page 6
6 how to access the motor (cont.) sensor drum roller motor heater connection once the panel from the right side is removed, you can access the motor, the sensor, the heater connection and the drum rollers. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 7
7 how to remove the motor remove the panel from the right side. Remove the blower; you must hold the motor shaft from the inside and unscrew the blower nut. Remove the rear panel, there are 13 screws that hold it in place . You must tilt the dryer to remove the four screws that hold the motor. Mabe ...
Page 8
8 how to remove the motor (cont.) to check the motor coils, check between the red and the white, the value is 39 Ω. Between the red and the blue, the value is 78 Ω and between the white and the blue, the value is 39 Ω. Mabe confidential and proprietary information-not for public disclosure.. January...
Page 9
9 how to remove the heater remove the panel from the right side. Remove the rear panel, there are 13 screws that hold it in place. Thermostat 145 °c 293 °f thermostat 110 °c 230 °f remove the screws from the heater assembly housing. Mabe confidential and proprietary information-not for public disclo...
Page 10
10 how to remove the heater (cont.) remove the heater’s harness protector located at the rear of the dryer. Disconnect the plug from the heater. Remove the wiring from the element. You can now replace the heater. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 11
11 how to check the temperature sensor the temperature sensor is located at the ventilation outlet under the drum. It controls the temperature inside the drum. To replace it you must remove the right side panel. At room temperature, the resistance is 20 k Ω. If you increase the sensor temperature th...
Page 12
12 humidity sensor this dryer has a humidity sensor located over the drum. Each baffle has a humidity detector that touches the drum. When the humidity detectors no longer detect humidity, the information will be transmitted to the electronic control by the humidity sensor. Humidity sensor baffle me...
Page 13
13 how to remove the drum 1. Remove the top, see page 4. 2. Remove the right side panel and the left side panel and remove the motor, see pages 4 to 8. 3. Remove the control panel. 4. Remove the rear panel. 5. Remove the retainer from the ground on the drum . 6. You must be careful once the retainer...
Page 14
14 how to remove the drum (cont.) 7. Remove the nut from the drum. 8. Remove the control panel and the wiring from the electronic control. There are three screws on the top which hold the control panel. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 15
15 how to remove the drum (cont.) 9. Remove the front panel, there are three screws under the dryer which hold the front panel. 10. Remove the screw from each side of the top part of the front panel. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 16
16 how to remove the drum (cont.) 11. Remove the 6 screws around the door opening, remove the front panel and remove the retainer from the drum roller support. 12. Remove the drum. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 17
17 door switch to remove the door switch you must remove the front panel. Please note that if the door stays open more than 5 minutes and no setting is selected, the lighting will shut off. Mabe confidential and proprietary information-not for public disclosure.. January 2007.
Page 18
18 error codes error short description error description f0 if there is an error regarding rom / eeprom / flash / lcd f1 improper operation of the temperature sensor - sensor circuit open or short circuit - this error appears if the connection with the temperature sensor is open or there is a short ...
Page 19
19 error codes (cont.) - f0: all leds flashing. The flashing period is 1 second (it is on for 0,25 second and off for 0,25 second). - f1: led 1, led 6 and led 7 are flashing. The flashing period is 1 second (it is on for 0,25 second and off for 0,25 second). - f2: led 2, led 6 and led 7 are flashing...
Page 20
20 noise when the dryer is noisy, there are a few possible causes. Check the drum rollers, the blower, the motor installation and check to make sure the dryer is level and the leveling legs are resting on the floor. Abnormal noise normal noise press on the green button. Press on the green button. Ma...
Page 21: Wiring Diagram
21 wiring diagram 240 volts drum lamp mabe confidential and proprietary information-not for public disclosure.. January 2007.