MABIS 04-237-001 Instruction manual - page 10
Fig. 2
Fig. 3
16
1. Rest your elbow on a table with your palm
facing upward.
Raise your hand so that
the cuff is at the same level as your
heart, Fig. 1. Relax your hand.
2. Select the memory bank you want your
reading to be stored in by pressing the
User-Select button to alternate between
memory bank 1 or 2, Fig. 2. Press the
POWER button to confirm your selection.
3. Press the POWER button. This will turn
the power on, Fig. 3.
4. When the display appears as shown, Fig. 4, the
monitor is ready.
Proceed only after reading the previous sections of this manual.
Fig. 1
Fig. 4
17
Fig. 5
Fig. 6
Fig. 7
5. The cuff will automatically inflate to approximately
180 mmHg.
6. Once the cuff inflates to approximately
180 mmHg, measurement will begin, Fig. 5.
7. The unit will begin to automatically deflate.
The numbers appearing on the display will
decrease, Fig. 6.
8. When all air is deflated, the measurement
is complete. The unit will display your blood
pressure (systolic and diastolic) measure-
ments and pulse rate, Fig. 7.
9. Record your readings on a chart.
10. At this point, your measurement will be
automatically saved in memory. Up to
120 measurements can be saved into two
separate memory banks (60 each). Your
unit will automatically shut off after
approximately 1 minute.
This monitor inflates the cuff to approximately
180mmHg. If the system detects that the cuff needs
additional pressure, it will automatically reinflate to
approximately 220 mmHg.
If you need to take another measurement, wait a mini-
mum of 15 minutes between readings to allow for the
blood vessels to return to normal. The wait time may
vary depending on your individual physiological
characteristics.
Taking Your Blood Pressure Reading
Taking Your Blood Pressure Reading