Macab IP-1000 RX Operating Instructions Manual - page 5
Operating Instructions
5
CONNECTING AND OPERATING
1) Connect the HDMI signal sources (Such as DVD, STB etc) to HDMI Transmitter.
2) Connect CAT5e or 6 cables to both the Ethernet of the transmitter and Ethernet port of the
Receiver. (The cables must follow the standard of EIA-TIA 568B).
3) Connect the HDMI output (Such as HD-LCD, HD-DLP) into the Receiver.
4)
Connect the power supply into
Power port.
5) Connect the IR-TX receiving cables into IR-TX port on the back panel and affix the emitter onto the
source IR windows.
6) Connect IR-RX cable into IR-RX port on the receiver and affix the IR receiver in direct line of site
with the handheld remote control. It is recommended to affix the receiver on the display frame
/bezel or the display stand.
Please note: Insert/Extract cables gently.
TYPICAL APPLICATION
1) One to One
Transmitter Receiver