Mace Ins-50012-MS Manual

Page of 8

Download

Print this page

Bookmark us

Page

Ins-50012-MS Mace Security stand alone plastic reader and keypad

Suitability

Fitting

Exit button

(push to make)

9-5V DC

2V DC release current rating

must be less than A.

(fuse rating 1A)

* The diode current rating must

be equal to or greater than the

current in the release

08/2/2009

Security sensitive doors

Wet environments

Mounted on metal surface

Readers mounted together

between readers

12 inches

User cards are NOT supplied with this unit.

Grey

Black

White

+2V DC

S ecur it y Produc ts

Technical Support

Technical help is available: Monday - Friday 9am to 7pm (EST)

877-585-6223

support@mace.com

Documentation on all Mace Security Products can be found on our web site - http://www.macepro.com/

1 2 3 4 5 6 7 Next › »

Summary of Ins-50012-MS

Page 1
Page ins-50012-ms mace security stand alone plastic reader and keypad suitability fitting exit button (push to make) 0v 9-5v dc 2v dc release current rating must be less than a. * (fuse rating 1a) * the diode current rating must be equal to or greater than the current in the release 08/2/2009 securi...
Page 2: Fcc Compliance
Page 2 fcc compliance operation is subject to the following two conditions: () this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the ...
Page 3
Page 3 the factory user code is now set to 7890 enter 6 digit master code enter 6 digit master code * * * # press press press press setting the master code the first time the keypad is turned on the red and green leds flash alternately. This indicates a 6 digit master code must now be entered. »the ...
Page 4
Page # press changing the keypad backlight to exit programming mode enter 6 digit master code the red and green leds flash simultaneously indicating reader is in programming mode press and hold for 3 seconds * # = on = off { press } = default 0 # press setting multiple entry codes (maximum = 120) to...
Page 5
Page 5 remove power to the keypad resetting the keypad (including the master code) press and hold hold for 3 seconds once power is applied 2 re-apply power, still holding 2 once reset, the keypad will need a new master code set, as per the programming section 2 enter new 6 digit master code re-enter...
Page 6
Page 6 adding proximity tokens present the master token the red and green leds flash simultaneously indicating reader is in programming mode up to 2000 proximity tokens can be added to the keypad. Each token is allocated to a memory slot on the keypad. A note will need to be made of the memory slot ...
Page 7
Page 7 2,000 digits 8 digits digits sec 60 sec 9v dc 5v dc 30ma a -20°c (-°f) 55°c (3°f) ip67 2 3 / inch / 2 inch / inch voltage specifications operating temperature electrical environment dimensions min max width height depth current outdoor use features door open time silent operation can be used ...
Page 8
Page 8.