Summary of CM7
Page 1
U ser manual.
Page 2
P lease read this manual carefully before attempting to install the product every effort has been taken to ensure that these instructions are correct. Mach speakers a/s does not accept any liability for loss or damage caused or alleged to be caused directly or indirectly by these instructions. The c...
Page 3
T able of contents introduction ...................................................................................................................................................................................... 3 the c-range ..........................................................................
Page 4
I ntroduction thank you for purchasing a product from mach speakers a/s. Every effort has been made to ensure that our products meet your requirements and we sincerely hope that we will live up to your expectations. To get the most out of your mach speakers and ensure an easy and trouble-free instal...
Page 5
T he c-range the c-range has been designed specifically for professional installations as a high quality, ultra-flexible solution with either a u-bracket or eyebolts included in one convenient package. The cabinets have been shaped to achieve both an appealing and attractive appearance and very easy...
Page 6
D escription of the c-range speakers the range can be divided into 3 different groups of products: - cn o near-field top boxes and full-range speakers for medium spl application where ultimate sound quality is required at low-to-medium spl with low-to-medium projection and with wide dispersion. - cm...
Page 7
I nstallation your new mach c-range speaker is one of the most versatile products on the market and every possible effort has been made to make it quick and easy to install your product. The many different installation options available will be described below. M ounting points on the cabinet the mo...
Page 8
S pider bracket all cn and cm speakers are supplied with the revolutionary spider bracket shown below. The bracket can be mounted vertically and horizontally depending on the direction the speaker should be flown and enables easy mounting on the wall bracket with a minimum of time and effort. 1. 2. ...
Page 9
8 9 h ow to install your c-range speaker on the optional multibracket the c-range is available with an optional multibracket that represents the optimum solution for many types of wall and ceiling installations. Adjusting the angle loosen the vertical adjustment locking bolt, remove the locking pin ...
Page 10
To mount a cn or cm cabinet on a wall please use the following procedure 1. Find the correct position on the wall and mark where the base of the bracket should be positioned 2. Take the bracket and hold the base flat to the wall at the marked position. 3. Mark each hole with a marking tool or a penc...
Page 11
H ow to install your c-range speaker with the u-bracket all the smaller models in the c-range are supplied with a u-bracket as standard. For many installation purposes this bracket will be the optimum solution as it is very versatile and easy to use. Illustrated below are a number of ways to use the...
Page 12
H ow to mount speaker with eyebolts for some installations, especially of the larger speakers in the c-range, the ideal way to mount the speaker is by hanging the cabinet in a wire or chain attached to the speaker with an eyebolt. All mounting points use standard 10mm metric thread for maximum flexi...
Page 13
R otatable horn the cm-9 features a rotatable horn that allows the speaker to be flown vertically or horizontally and still maintain the required dispersion. The default positioning of the horn is for horizontal installation. If vertical installation is required remove the grille and unscrew the hor...
Page 14
C onnection the c-range has a flexible and user-friendly connection module with double connectors, which gives the user the choice of using nl-4 connectors or screw terminals. H ow to connect speaker cable to barrier strip terminals the barrier strip terminals are a quick and easy way to connect the...
Page 15
C onnecting to amplifier the way you connect your c-range speakers to your amplifier depends on the type of installation that you are making and the type of amplifier used. C ables to get the best possible performance from your c-range speaker, use high quality cable. Cables with high capacitance, h...
Page 16
P arallel system if you require more speakers for better sound distribution and you only have a limited number of output channels on your amplifier, you can connect more than one speaker to each channel. This can be done by linking the speakers for each channel in parallel as illustrated. However, a...
Page 17
16 17 passive mode active mode s ystem configuration for maximum flexibility, all mach cm speakers can run either passive, using the built-in crossover, or active/biamped with direct drive of each transducer. The speakers are all set up as passive from the factory but can easily be switched over to ...
Page 18
16 17 passive mode active mode 1. 2. 3. 4. S witching between passive and active mode for the cn7, cn8, cm7 and cm9 mach has developed a completely new, extremely safe and user friendly way to switch between passive and active mode. The procedure is very quick and simple: 1. Unscrew the terminal pla...
Page 19
18 19 amplifier sub terminal on speaker output amplifier mains input output mains input crossover m.20.06 1+/1- 1+/1- output mains input to sub bi-amp 3-way with subwoofer in a bi-amp 3-way system the internal crossover is used for mid/high frequencies and the m20.06 controller is used to filter out...
Page 20
18 19 bi-amp 2-way in bi-amp 2-way configurations each transducer is driven by a separate amplifier and the system is crossed over directly by the m20.06 for 2-way full range output. Amplifier lf terminal on speaker output amplifier hf mains input output mains input crossover m.20.06 1+/1- 2+/2- out...
Page 21
20 21 amplifier sub terminal on speaker output amplifier lf mains input output mains input crossover m.20.06 1+/1- 1+/1- output mains input output amplifier hf mains input 2+/2- to sub triple-amp 3-way in a triple-amp 3-way system each transducer is run by a separate amplifier and all signal modulat...
Page 22
P ainting the speaker the c-range cabinets are made of mdf coated with mach safecoat and can be painted easily to match the color scheme of your venue. To paint your speaker please follow the procedure below: 1. Remove the front grille 2. Degrease the cabinet on all surfaces with denatured alcohol/m...
Page 23
M aintenance of speakers although speaker systems normally only require very limited maintenance there are several things you can do to ensure that your mach system sounds as good 3 years after installation as on the day you bought it: never overload your system – stay within the specified limits fo...
Page 24
T echnical information c n 7 a unique, full range near-field speaker combining hi-fi properties with medium spl in an ultra compact design. Featuring 18 flying points - four of which are fully adjustable - and a customized u-bracket included as standard with every speaker, the c-range is an extremel...
Page 25
Specifications power rating iec268: 300 watt power rating peak: 1200 watt sensitivity 1w/1m: 95 db max spl, calculated long term: 120 db max spl, peak: 126 db frequency response +/-3db: 65 hz - 20 khz dispersion angle: h 90deg x v 60degrees nominal impedance: 4 ohm recommended amplifier: 400 watt in...
Page 26
Specifications power rating iec268: 300 watt power rating peak: 1200 watt sensitivity 1w/1m: 96db (avg.) max spl, calculated long term: 121db max spl, peak: 127 db frequency range +/-3db: 80 hz - 20 khz dispersion angle avg: h 90 x v 60 degrees nominal impedance: 8 ohm recommended amplifier: 400 wat...
Page 27
C m 9 a unique, full range near-field speaker combining hi-fi properties with medium spl in a compact design. Featuring 18 flying points - four of which are fully adjustable - and a customized u-bracket included as standard with every speaker, the c-range is an extremely versatile installation speak...
Page 28
W arranty for information on the warranty conditions specific for your country please refer to the material handed to you by your local mach distributor. D eclaration of conformity manufacturer: mach speaker a/s perspektivvej 2 9900 frederikshavn denmark we, mach speakers a/s, declare under our resp...
Page 29
O rdering spareparts in the unlikely event of your speaker breaking down some of the components can be ordered as spare parts. For information on how to order in your country please contact your local supplier or contact the head office in denmark at the following address: mach speakers a/s perspekt...
Page 30
28 29 c m 12 specifications: power rating iec268: 325 watt power rating peak: 1300 watt sensitivity 1w/1m: 98.5 db max spl, calculated long term: 124 db max spl, peak: 130 db frequency response +/-3db: 70 hz - 18 khz dispersion angle: h 90deg x v 75deg nominal impedance: 8 ohm recommended amplifier:...
Page 31
30 31 c m 15 c m 18 specifications: power rating iec268: 450 watt power rating peak: 1800 watt sensitivity 1w/1m: 102 db max spl, calculated long term: 129 db max spl, peak: 135 db frequency response +/-3db: 58 hz - 20 khz dispersion angle: h 90deg x v 55deg nominal impedance: 8 ohm recommended ampl...
Page 32
C i range overview a perfect complement to the c-range in most retail and club environments is the mach ci series. All mach ci in-fill speakers have wide, even dispersion that ensures good coverage in low ceiling applications. Specifications: power rating iec258 50 watt power rating peak 200 watt re...
Page 33
32 supplier mach speakers a/s www.Mach.Dk.