Mach M42i User Manual - M I W 6 2
4
C
O N N E C T I O N S
Always use high quality speaker cable for the best sound quality and system performance.
All in-fill models are easily connected using push terminals. For correct polarity, connect the
red (+) terminal on the amplifier to the red terminal on the speaker. Likewise, connect the black
(-) terminal on the amplifier to the black terminal on the speaker. If one speaker is connected
with reverse polarity, the result is a strong decrease in bass output and lack of focus in the
mid/high frequencies.
If supporting the in-fill top-boxes with the M208i subwoofer, connect the high-pass output on
the M208i to the top-box input. Connect only one pair of top-boxes to the subwoofer output.
Important! Do not connect the subwoofer high-pass output to the amplifier
output: this will cause damage to the amplifier.
M I W 6 2
I N S T A L L A T I O N
As a rule of thumb, correct coverage is obtained by spacing MIW62’s at a distance similar to the
height of the room.
With the 100V module included, the output of the speaker can be controlled individually by
connecting it to the - (minus) terminal and to one of the output options shown below:
The cut-out dimensions for MIW62 are 278 x 190 mm (11" x 7½").
The minimum depth required is 80 mm (3.15") without the 100V module and 100 mm (4") with
100V module.