1604-vlz 16 channel mic/line mixer service manual contents pg. Quick parts 1 block diagram 2 channel schematic 3 pod section schematics 4-6 pod section pcb layout 7-8 main section schematics 9-14 main section pcb layout 15 jumper location and pinout 16 power supply 17 mackie designs inc., 16220 wood...
Quick parts pcb - pwr 055-066-00 pcb - pod 055-219-00-01 pcb - main 055-220-00-01 iec recepticle 400-009-00 bnc jack 400-010-00 pwr switch 500-013-00 phantom sw 500-016-00 chassis top 550-172-10 chassis bottom 550-173-00 pod top 550-174-00 pod bottom 550-175-00 cable plate 550-176-00 transformer 100...
Main l sub 3 main r sub 2 sub 1 sub 4 aux 1 aux 2 aux 3 aux 4 aux 5 aux 6 sip l sip r pfl logic 75hz hpf mid hi 80 100-8k 12k lo l r 1 2 3 4 sip l sip r pfl phantom power (global switch) trim mic in line in direct out (ch's 1-8 only) insert low cut -20 (flicker) solo (glow) ol (flicker) mute (glow) ...
Cr1604-vlz, channel 3.
Cr1604-vlz, pod section sheet 1 4.
Cr1604-vlz, pod section, sheet 2 5.
Cr1604-vlz pod section, sheet 3 6.
Rev c cr1604-vlz pod pcb layout, left half 7.
Rev c cr1604-vlz pod pcb layout, right half 8.
1604-vlz main section, sheet 1 9.
Cr1604-vlz main section, sheet 2 10
Cr1604-vlz main section, sheet 3 11.
Cr1604-vlz main section, sheet 4 12.
Cr1604-vlz main section, sheet 5 13.
Cr1604-vlz main section, sheet 6 14.
Cr1604-vlz main board pcb layout rev b channels 3-14 not shown, reffer to channels 1-2..
J1 channel 1 gnd 1 2 channel 1 trim a channel 1 gnd 3 4 channel 1 trim b channel 1 gnd 5 6 channel 1 in channel 1 gnd 7 8 channel 1 di out channel 2 gnd 9 10 channel 2 trim a channel 2 gnd 11 12 channel 2 trim b channel 2 gnd 13 14 channel 2 in channel 2 gnd 15 16 channel 2 di out channel 3 gnd 17 1...
Cr1604-vlz power supply ‰.
1604-vlz auxiliary modifications in addition to the modifications shown in the 1604-vlz owner’s manual, there are two rather lovely and optional mods for the signal routing of aux 3/4 and 5/6. Ul warning caution! These modification instructions are for use by qualified personnel only. To avoid elect...
The mackie fixer mackie designs service news to make aux 3/5 and aux4/6 pre-eq and pre-fader aux 3/5 1. Cut the trace between the round and square pads at point d on the channel to be modified. 2. Solder an insulated jumper wire from the square pad at d to the square pad at f on the same channel. ...
The mackie fixer mackie designs service news ©1999, ©1996, mackie designs inc. All rights reserved 1604-vlz aux mod, sheet 3 of 3.
