Mackie DC16 Owner's Manual - page 55
DC16 Owner’s Manual
55
• RECALL Button
This button recalls snapshots via DC16. Pressing the RECALL button once causes the button’s LED
to flash red. In order to recall this snapshot, you will need to press the button a second time (within five
seconds of the first press) to confirm the recall. After five seconds of inactivity, the store button’s LED
reverts back to its solid red state.
After a snapshot has been recalled, the currently loaded snapshot indicator [>] changes.
Furthermore, that same snapshot highlights, indicating that it has been recalled. It will remain
highlighted until an arrow button is pressed, highlighting another snapshot.
The recall button’s LED will remain solid red when it is available for use. This is always
the case unless: (1) the button has been pushed (in which case it will flash red for
the aforementioned five second period) or (2) “New...” is the highlighted snapshot.
After all, a new snapshot cannot be recalled, only stored!
As with Master Fader, recalling snapshot “0 - Default” on DC16 will set the Master Fader
to its default (which – for all intents and purposes – is a zeroed out board). Snapshot
“0 - Default” is always listed first and cannot be renamed, replaced or deleted; only recalled.
• STORE Button
This button stores snapshots via DC16. Tapping the STORE button will store the current state
of the console [the faders, EQs, gates and compressors, etc.] that you just set to a new snapshot
or as a replacement.
Here, pressing the store button once causes the button’s LED to flash orange. In order to store this
snapshot, you will need to press the button a second time (within five seconds of the first press)
to confirm the store. After five seconds of inactivity, the store button’s LED reverts back to its solid
orange state.
Creating a NEW SNAPSHOT is as simple as highlighting the “New...” snapshot at the bottom
of the list and following the directions outlined above.
REPLACING A SNAPSHOT is as simple as highlighting any current snapshot on the list
and following the directions outlined above. Please be aware that doing so erases all
of your previously stored settings.
The store button’s LED will remain solid orange when it is available for use. This is always
the case unless: (1) the button has been pushed (in which case it will flash orange for
the aforementioned five second period) or (2) “Default” is the highlighted snapshot.
After all, the default snapshot cannot be stored, only recalled!
• MORE Button – NYI
The MORE button is Not Yet Implemented [NYI], but will eventually lead to more advanced show
operation possibilities. Stay tuned!
Ok, fine...the MORE button does one thing at press: the button’s LED illuminates white
when pressed!
D
EFAULT
1
I
NTRO
3
C
RY
B
OYZ
*
>
N
EW...
2
R
AWK
I
T!
D
EFAULT
1
I
NTRO
3
C
RY
B
OYZ
*
>
N
EW...
2
R
AWK
I
T!
D
EFAULT
1
I
NTRO
3
C
RY
B
OYZ
*
>
N
EW...
2
R
AWK
I
T!