Fussion 3000 active full range sound reinforcement speaker system user’s manual.
Caution avis risk of electric shock do not open risque de choc electrique ne pas ouvrir caution: to reduce the risk of electric shock do not remove cover (or back) no user-serviceable parts inside refer servicing to qualified personnel attention: pour eviter les risques de choc electrique, ne pas en...
3 ©2000 mackie designs inc. All rights reserved. Printed in italy. Rev. B lend me your ears exposure to extremely high noise levels may cause permanent hear- ing loss. Individuals vary considerably in susceptibility to noise-in- duced hearing loss, but nearly everyone will lose some hearing if expos...
4 introduction thank you for choosing mackie designs’ active sound reinforcement speaker systems. The fussion 3000 is a full-range, me- dium throw, active loudspeaker system capable of extremely high sound pressure levels and wide dispersion. With almost 2000 watts of low-distortion built-in power, ...
5 rear panel description power switch switch up to turn the fussion 3000 on, and switch down to turn it off. Make sure the signal source’s level control is down before you turn it on. Power/protect indicator when the power switch is turned on, and the linecord is connected to an active ac mains supp...
6 main in this is a female xlr-type connector that accepts a balanced line-level signal from your mixing console or signal processor. Loop out this is a male xlr-type connector that produces exactly the same signal that is connected to the main in jack. Use it to daisy-chain several fussion 3000s to...
7 placement the fussion 3000 active loudspeakers are designed to sit on the floor or to be sus- pended by the rigging points. You can stack cabinets vertically. If you do, turn the upper cabinet upside down so the high-frequency driver is closest to the high-frequency driver in the lower cabinet. Yo...
8 rigging the fussion 3000 cabinets are fitted with rigging points shown in the diagram below. Warning: never at- tempt to suspend the fussion 3000 active loudspeakers by their handles. If you want to suspend them, use the rigging points only. You can suspend the fussion 3000 from the four fly point...
9 • is the power/protect led lit red? Make sure there is at least six inches of free space behind the heatsinks. Allow the fussion 3000 to cool off and it will turn back on. Poor bass performance • check the polarity of the connections between the mixer and the loudspeak- ers. You may have your posi...
10 repair service for the fussion 3000 is avail- able only from one of our authorized domestic service stations or at the factory service center, located in whitinsville, massachusetts. Service outside the united states can be obtained through local dealers or distributors. If your fussion 3000 need...
11 fussion 3000 specifications line input power us: 115v, 60hz recommended amperage service: 20a recommended ac connector: 3-pin twistlock 250vac, 20a male europe: 230v, 50hz recommended amperage service: 16a recommended ac connector: 3-pin iec 250vac, 16a male in-rush current protection: transistor...
Some of the people at our woodinville, washington factory who helped design, build, sell, and support your product. Some of the people at our woodinville, washington factory who helped design, build, sell, and support your product. ® ® ® ™ mackie designs inc. Mackie designs inc. 16220 wood-red rd. N...
