1 swa1801 repair manual active.
2 these instructions are intended to help restore any ailing swa1801 active subwoofer back to factory working conditions. They show how to remove and replace the woofer and amp assembly. Please contact mackie tech support (1-800-898-3211) to receive a service request number and order number for part...
3 led pcb replacement: 3 carefully begin to remove the front panel. The wave guides are a great place to grip for stability and support. Do not fully remove front panel as the cable is still attached to the led pcb assembly. 2 keep the 20 screws and washers in a safe place. 4 carefully remove the ca...
4 6 carefully remove led pcb assembly from back side of front panel. A fl athead screwdriver may aid in removal of led pcb assembly if it is sticking. 5 use phillips head screwdriver to remove one screw from center of led pcb assembly. 7 the hard part is done, the rest is easy! Place new led pcb ass...
5 woofer replacement: 1 follow steps 1-4 of led pcb replacement, as the front panel will need to be removed in order to access the woofer. 2 eight screws need to be removed from the woofer using 5mm allen wrench. 3 keep the eight screws in a safe place. + - 8 1 2 3 4 5 6 7 4 carefully begin to remov...
6 woofer replacement continued: 6 remove cables from terminals simply by pushing down on terminal and pulling out cable. 7 this is what it looks like with the front panel and woofer both removed. Place new woofer (part #0012184) where the old one was. Follow the same steps as above, but backwards 6 ...
7 amp assembly replacement: 3 last remaining two screws located on the bottom of the swa1801. 2 two screws located on the top of the swa1801 patiently awaiting removal. 1 four screws need to be removed from the amp assembly using a 5mm allen wrench. The screws are located at the top and bottom of th...
8 7 place the new amp assembly (part #0005687) where the old one was. Follow the same steps as above, but backwards 6 to 1. Remove the serial number from the faulty amp assembly (as shown in picture above) and place on the new amp assembly. Power up the swa1801 and relish in the fact that you just r...
