Maco Antennas M106C Assembly Instructions Manual - page 3
(45”)
(98”)
I
PLASTIC
CAP
I
-
\
DRIVEN
ELEMENT
GAMMA MA
FIRST DIRECTOR’
2” O.D. MAST
SECOND’
(CUSTOMER
DIRECTOR
FURNISHED)
THIRD
RED PLASTIC
CAP
DIRECTION OF
RADIATION
DIRECTOR
SLACK PLAS
DIRECTOR
GAMMA MATCH-----”
FIRST DIRECTOR’
SECOND DIRECTOR
2”
(CUSTOMER I
HORIZONTAL POLARIATION
THIRD
DIRECTOR
FOURTH
DIRECTOR
RED PLASTIC
CAP
DIRECTION OF
RADIATION
FIGURE 1
GENERAL INSTRUCTIONS
This drawing shows a view of the antenna assembled. The
may be used vertically or
horizontally. These instructions and FIGURES 2 through 4 show the correct assembly instructions. It is
highly recommended that rope be put in the elements to prolong their life. All hardware should be tightened
securely, and then coated with silicon rubber sealant or similar compound to prevent loosening from wind
vibration.
Take care to locate all parts accurately per dimensions given. Complete each step as instructed
before going on to following steps.
Upon completion of assembly, install the red plastic cap
on the director end of the antenna,
and the black plastic cap (PL5) on the reflector end. This will allow you to determine at a glance the direction
of transmit and receive.
2