Maco Antennas M107C Assembly Instructions Manual - page 3

I

 (41.5)

DRIVEN ELEMENT

GAMMA 

FIRST DIRECTOR

DIRECTION OF

RADIATION

THIRD 

SECOND DIRECTOR

DIRECTOR

2” 0 D. MAST

VERTICAL POLARIATION 

FOURTH DIRECTOR

FIFTH DIRECTOR

BLACK PLASTIC CAP (PL4)

REFLECTOR

GAMMA MATCH

 (83”)

 (41.5”)

 (41 

 08M (83”)

FIRST DIRECT

THIRD DIRECTOR

FOURTH DIR

DIRECTION OF

RADIATION

 FIFTH

RED PLASTIC CAP 

HORIZONTAL POLARIATION

FIGURE 1

GENERAL INSTRUCTIONS

This drawing shows a view of the antenna assembled. The 

 may be used vertically or

horizontally. These instructions and FIGURES 2 through 4 show the correct assembly instructions. It is

highly recommended that rope be put in the elements to prolong their life. All hardware should be tightened

securely, and then coated with silicon rubber sealant or similar compound to prevent loosening from wind

vibration.

Take care to locate all parts accurately per dimensions given. Complete each step as instructed before

going on to following steps.

Upon completion of assembly, install the red plastic cap 

 on the director end of the antenna,

and the black plastic cap (PL4) on the reflector end. This will allow you to determine at a glance the direction

of transmit and receive.

2