Macpower & Tytech MantaRay User Manual & Installation Manual

Manual is about: External Storage Enclosure for 3.5” Hard Drives

Summary of MantaRay

  • Page 1

    Copyright © 2000-2003 by macpower peripherals ltd. - www.Macpower.Com.Tw user manual & installation guide external storage enclosure for 3.5” hard drives the mantaray.

  • Page 2: Table of Contents

    Table of contents t able of c ontents - 1 - chapter 1 - introduction - 1 - i con k ey - 1 - t he m anta r ay - 1 - a vailable i nterfaces - 1 - f eatures - 2 - o ver v oltage p rotection (ovp) - 2 - l ow v oltage d etection (lvd) - 2 - i nverse -p olarity p rotection - 2 - a utomatic d etection of t...

  • Page 3: Chapter 1 - Introduction

    Chapter 1 - introduction icon key throughout this manual you will see icons on the left margin that denote either notes or special remarks as outlined below: general notes and tips remarks for pc users and microsoft windows os remarks for mac users and apple macintosh os the mantaray the 'mantaray' ...

  • Page 4: Features

    If the red led is blinking and not on permanently, there is no problem with your unit. This only indicates the spin up of your drive or a temporary spike or slump in the power consumption and does not harm your drive or device at all. The product can be used normally. Features mentioned in this manu...

  • Page 5: System Requirements

    Usb driver for win98/se only available for the usb 2.0 version. Mac os 8.6 users should use usb extension 1.41 or firewire extension 2.6 and later, to be able to use usb 1.1 or 1394a. Package content may vary, depending on vendor & version. System requirements pc requirements • minimum intel process...

  • Page 6: Preparing The Enclosure

    Your unit might come with an installed hard drive. Before opening such an enclosure, please read the warranty and any other notes from your vendor carefully before doing so, as this might void your warranty. Chapter 2 - installing the hdd preparing the enclosure remove the feet and the 4 screws on t...

  • Page 7: Hard Drive Assembly

    The hard drive jumper settings should be master or factory default. Be careful not to damage any cables or components and double check the connection between the cables, the bridge board and your hard drive before you close up the case. Hard drive assembly connect the ata cable and the power line to...

  • Page 8: Chapter 3 - System Set Up

    Most problems occur due to driver problems on the host card side! Chapter 3 - system set up connection to your computer a few tips on how to connect your external storage enclosure: • make sure your pci host card is installed correctly • double check that the host card driver is up to date • if requ...

  • Page 9

    If the system doesn’t recognize the drive, turn on the power first, before connecting the usb/firewire cable. Win98 does not support firewire, you need to upgrade your os to win98se or higher. The mantaray 800+ does not support win98/se, you need to upgrade your os to winme or higher. For safe remov...

  • Page 10

    If the system doesn’t recognize the drive, turn on the power first, before connecting the usb/firewire cable. For mac os 8.6, the usb extension has to be at least v1.41. For mac os 8.6, the firewire extension has to be at least v2.6. For save removal of your drive and to assure that no data is lost,...

  • Page 11: Partitioning & Formatting

    You can choose to create several partitions but be aware that if you want to change this at a later point, it’s required to format the drive again or use 3 rd party software. Win98/se and winme do not recognize ntfs formatted drives, so if you want to use your drive on those platforms, we recommend ...

  • Page 12

    Mac os does not recognize ntfs formatted drives, to use your device on both platforms, we recommend you using fat32. If you use win2000 or winxp and fat32, the biggest single partition you can create will be 32gb. To create larger partitions, you need to use the dos command under win98se or winme or...

  • Page 13

    If you want to use your drive on a pc running microsoft windows as well as on your mac, we recommend you to use a pc to format the drive. Choose fat32 when formatting and do not change anything on the partition or format on your mac, otherwise the pc will not be able to recognize the drive anymore. ...

  • Page 14: Technical Questions

    Please read your warranty carefully, as this may vary between different vendors! Technical questions : for rma and other questions, please contact your vendor or check out their online support area! About this manual : this manual covers all interfaces and combinations for the mantaray enclosure. Im...