Tm air star.
Table of contents 1. Cautions and safety 2. Package contents 3. Tools needed 4. Fan clearance / placement 5. I-beam mounting 6. Glulam mounting 7. Spanning mount / mount assembly 8. Extention assembly 9. Blades/ blade retainers 10. Blade retainer assembly 11. Wiring guide/ cat5 b.
Caution and safety pg 1. Read and follow this maual befroe operating the fan. Read these safety practices before installing, operating or servicing the fan. Failure to follow these safety practices could result in death or serious injury. Be certain to follow the instructions in this manual. If you ...
Package contents power unit image of hardware and mount remote pg 2..
1. Socket set and ractchet (deep and short wall) 2. 3/8 allen key 3. Magnetic level 4. Phillips and flat head screw driver 5. Network crimping tool (if standard connection will not work.) 6. Torque wrench (not shown) tools required 3. 1. 2. 4. 5. Pg 3.
Roof slope= rise/run fan diameter run=12" rise=?" no obstructions in this area (15% of fan diameter) total fan height approximately19.5" the extension lengths below are minimum recomendations only, based soley on roof pitch and fan diameter. Other consideration must be evaluated when determining ext...
I-beam mounting i-beam assembly exploded view for installations with i-beams use macroair i-beam kit (pn 60-50106-00). To properlly install mount be sure to use hang mount along slope of the roof. For ease of installation the unistrut for our i-beam mount can be installed in two differant configurat...
Glulam mounting glulam assembly exploded view glulam installation utilizes unistrut in conjunction with our glulam bracket for installations containing glulam beams. Installation on glulam beams will use macroair glulam mounting kit (pn 60-50108-00). Installing the mount alonge the slope of the roof...
Model of spanning mount loosely install the mount hardware prior to installing fan. Once the fan is installed and level, tighten mount hardware down. Spanning mount also utilizes unistrut for spanning mount installations. Power unit mount exploded view pg 7.
Extension assembly exploded view when extension is needed assemble between mount and power unit with provided hardware. (refer to chart on pg 4 for size recomendations) pg 8.
While installing blades be sure to install the blade reatainer links by over lapping the reatainers. Refer to image above for exploded view. Blade bolts must be torqued to 23 ft lbs. Blade retainer installation pg 9.
Blade assembly image this image represents the correct installation of the blade and blade reatainer links. Pg 10
Cat5 b pinout chart a coulpler may also be use to extend the length of the remote cable connection. In the case where a long cat5 cable is required please follow the cat5 b standard. The image above show how to route cables through extension. The image above shows the cable from the top of the fan w...
Macroair 794 south allen street san bernardino, ca 92408 p 909.890.2270
