MadBoy BLENDER-422 Owner's Manual - page 5
4
Use the TAPE OUT jacks to connect, for example, a tape deck for recording
applications.
Use the PHONES jack to connect a commercially available pair of headphones.
These are the balanced 1/4' jack MAIN OUTPUTS of your machine that can be
used to drive, e.g.a power amplifier.
Connect the
RETURN
connector to the
MAIN
bus.
The AUX SEND connector provides the monitor signal of your machine, for
example, to control a monitor amplifier or active monitor speaker.
6
7
8
9
10
11
12
13
14
15
16
Use the PAN control to adjust the signal position on the stereo basis.
Use the AUX control to determine the channel volume sent to the AUX mix
bus. When set fully to the
left, the channel volume in the AUX mix is zero.
The CHANNEL control adjusts the volume of the corresponding channel
17
18
19
20
21
22
23
The PHONES control governs the headphones volume.
Use the MAIN MIX control to set the overall volume level of your machine.
The TAPE IN jacks (on stereo RCA) allow for the connection of play-back devices
such as CD players, etc.
5
The
2TK TO
Switch
, The signals sent to the
CONTROL ROOM
or the
MAIN
The
DFX RETURN
adjusts the signal level sent from the
internal digital effect unit to the
MAIN
The
POWER LED
will be turned on when start working
The
DFX MUTE
switch is the internal effect on or off
The
DIGITAL MULTI EFFECTS
Press the key stroke
UP
and
DOWN
,you will get the perfect never
berative effect you need,These functions can be turned up many
kinds of effective posture
01-10 reverb halls
11-20 reverb plates
21-30 echo/reverb
31-40 chorus1
41-50 stereo delay
51-60 mono delay
61-70 special reverb halls
71-80 special plates
81-90 special delay mono
91-99 special doubling
The power switch
The phantom power switch
The power jack
WWW.MADBOY-AUDIO.COM