MadBoy BONEHEAD-206 User Manual - page 4
1
WWW.MADBOY-AUDIO.COM
MODEL:BONEHEAD-206
WWW.MADBOY-AUDIO.COM
SERIAL NO.:
Rear panel of the BONEHEAD-206
Connecting a passive speaker (without amplifier) and power cable.
What you will need
- Another speaker of BONEHEAD-206 without amplifier on it. Speaker included
- S
peaker cable (red and black). Cable included.
1. Connect one end of each speaker cable to the speaker output (1)/input(1B) red to red and black to black. (1)
2. Connect the power cable to the AC input, on BONEHEAD-206 rear panel. (2)
- Power cable. Cable included.
3. When cable is inserted to AC input of the BONEHEAD-206, connect another end of the cable to AC-wall outlet.
4. After connecting all necessary cables, players etc. (see page 4) turn power on from power switch. (3)
NOTICE! When connecting cables etc. make sure power is turned off
and volume (4) is turned down (in BONEHEAD-206 and ie. amplifier)! This is to avoid any unwanted noise/hazard.
SPEAKER INPUT
2
3
4
5
6
1B
1. SPEAKER OUTPUT (to connect passive BONEHEAD-206 speaker)
1B. SPEAKER INPUT (in rear panel of passive BONEHEAD-206 speaker)
2. AC INPUT (to connect power cord)
3. POWER SWITCH (to turn power on/off)
4. VOLUME (to turn volume level up and down)
5. LINE IN (to connect ie. CD-player, MP3-player etc. with RCA-stereo cable)
6. LINE OUT (to connect ie. active subwooffer with RCA-stereo cable)
3
Getting connected
Passive speaker