Maestro Wireless Solution E220 Series Quick Start Manual - page 13
of
22
E220 Series| QUICK START GUIDE
http://support.maestro-wireless.com
Page | 13
5.1.5
Connect the router LAN port with the computer LAN port.
Figure 8:
Connecting the router and computer LAN port
5.1.6
Connect the AC power to the DC in connector, then connect the Micro-Fit connector to
the power input, located on the LAN-side panel of the Maestro Router.
Plug the AC cord into a standard AC receptacle as shown below.
The power LED will light when power is applied.
Figure 9:
Connecting the AC power connector
5.1.7
An alternate option is to power the Maestro Router over Ethernet port as the WAN port
supports PoE (Power over Ethernet).
NOTE:
Please refer to the section Power over Ethernet on Appendix 1 for connections
example.