Magellan 1000M Quick Manual - W A Y P O I N T S

3.

Press the POS key. The time to obtain your first fix will be

roughly 2 

 minutes in 2D and 3 

 minutes in 3D depending

on the distance and time from the last position fix, and other

factors.

4.

When using the exterior antenna, make certain the units attached

antenna is folded downward within the shield of the quick-release

 and that the unit is connected to power.

Averaged Positions

You may obtain averaged positions by pressing the RIGHT ARROW key

when you are on the position 

 screen.

NOTE: You must be taking  fixes. After 999 fixes are

averaged together, the unit will start the process

over.

Press the clear key while on the averaging screen to restart the

averaging process.

WARNING:  Do not use the position fix if this

warning symbol appears and the GQ   3.

W A Y P O I N T S

To view, press WPT and RIGHT ARROW.

To 

 a position fix, press ENTER while viewing any position.

To enter a waypoint, press WPT and ENTER to begin data entry.

To rename, select 

 and press ENTER.

To erase,  select 

 and press CLEAR.

To 

 all waypoints. press AUX 6.

NOTE: Keep a written record of all waypoints.

TARGET

The target function will let you calculate the coordinates for a remote

target position (given an azimuth and distance), or the azimuth and

distance to a target (given a position). Press the TARGET key, the first

screen will let you select between calculating a position or a range and

azimuth. Select by pressing the RIGHT ARROW key. Press the

DOWN ARROW

key when you are done; the unit will then ask you to

enter the pertinent information.

For Position . . .

If you select position, the unit will ask where you would like to calculate

from. You may select from your waypoints or last fix or averaged position.

Most likely you will use your lastfx position. Enter your range, azimuth,

and elevation angle to your target. The unit will calculate the targets

position.

For Range and Azimuth

If you select range and azimuth, the NAV 

 unit will ask where you

want to calculate from (lastfx, avg, and waypoints) and where you want to

calculate to (waypoints). The unit will then calculate the distance and

azimuth to the target.

S I N G L E   F I X   O P E R A T I O N

You may run the unit in single fix operation to help conserve battery

power. In single fix operation the NAV 

 is designed to cycle off

if you press no key for 120 seconds, only take one fix when you push

the POS key and no velocity related information is available. You

may access single fix operation under battery operation under the

SETUP key.