1. DL manuals
  2. Magellan
  3. Security System
  4. DIY
  5. Installation Manual

Magellan DIY Installation Manual - Contents

Manual is about: Wireless Home Security System

Summary of DIY

  • Page 1

    Diy wireless home security system installation guide diysecurity.Co.Za.

  • Page 2: Contents

    Contents introduction part 1: planning .................................................................................................................................................. 3 part 2: control panel installation ................................................................................

  • Page 3: Introduction

    Www.Diysecurity.Co.Za 3 introduction part 1: planning the fi rst thing you’re going to want to do is fi gure out where you want to put the control panel. Typically, it’s easiest for everybody to place it by the door you use most frequently you can always add extra keypads to your magellan system. Yo...

  • Page 4: System Planning Diagram

    Www.Diysecurity.Co.Za 4 system planning diagram layout diagram example mounting guidelines mounting locations • mounting locations affect the overall performance of the wireless system • in order to ensure the best possible signal reception, the following list of criteria should be respected wheneve...

  • Page 5

    Www.Diysecurity.Co.Za 5 figure 1 • the “dead spot”, or area where the rf signal is weak or non-existent, varies from one transmitter to the next • mounting the receiver as central as possible to the transmitters will help in avoiding the “dead spots” • do not mount the transmitters too close to each...

  • Page 6

    Www.Diysecurity.Co.Za 6 pmd85 outdoor 45kg pet detector installation guide diysecurity.Co.Za.

  • Page 7

    English beam patterns the mg-pmd85 series features the following beam patterns: installation after selecting the detector’s location, drill or punch out holes for the mounting screws as shown in figure 1. Avoid placing the detector within proximity of sources of interference such as direct sunlight,...

  • Page 8

    English beam patterns the mg-pmd85 series features the following beam patterns: installation after selecting the detector’s location, drill or punch out holes for the mounting screws as shown in figure 1. Avoid placing the detector within proximity of sources of interference such as direct sunlight,...

  • Page 9

    Www.Diysecurity.Co.Za 7 pmd75 45kg pet detector installation guide diysecurity.Co.Za.

  • Page 10

    Mgpmd75-ti00 english at the recommended height of 2.1m (7ft) ±10%, the mg-pmd75 motion detectors provide full coverage from 1.5m (5ft) to 11m (35ft). The installation height is measured from the center of the detector (figure 1). All measurements shown in figures are expressed in meters and (feet). ...

  • Page 11

    Mgpmd75-ti00 english at the recommended height of 2.1m (7ft) ±10%, the mg-pmd75 motion detectors provide full coverage from 1.5m (5ft) to 11m (35ft). The installation height is measured from the center of the detector (figure 1). All measurements shown in figures are expressed in meters and (feet). ...

  • Page 12: Pmd1 18Kg Pet Detector Guide

    Www.Diysecurity.Co.Za 8 pmd1 18kg pet detector guide diysecurity.Co.Za.

  • Page 13

    English at the recommended installation height of 2.1m (7ft) ±10%, the mg-pmd1p will provide full coverage from 2m (6.5ft) to 15m (50ft), without any dead zones (figure 2). Avoid placing the motion detector in proximity to potential sources of interference such as: reflective surfaces, direct air fl...

  • Page 14

    English at the recommended installation height of 2.1m (7ft) ±10%, the mg-pmd1p will provide full coverage from 2m (6.5ft) to 15m (50ft), without any dead zones (figure 2). Avoid placing the motion detector in proximity to potential sources of interference such as: reflective surfaces, direct air fl...

  • Page 15

    Www.Diysecurity.Co.Za 9 door contact installation guide diysecurity.Co.Za.

  • Page 16

    Mgdctxp2-ti05 www.Paradox.Com printed in canada - 12/2007 instructions instrucciones wireless 2-zone door contact (universal transmitter) mg-dctxp2 v3.0 no se debe cortar, doblar o alterar la antena. Evitar ubicar el contacto de puerta cerca de o sobre metal pues esto podría afectar la transmisión a...

  • Page 17: Dc Power Connect

    Www.Diysecurity.Co.Za 10 dc power connect diysecurity.Co.Za.

  • Page 18

    Www.Diysecurity.Co.Za 12 • in extreme situations, the refl ected rf wave (b) inverts and cancels out the direct path rf wave (a) • to remedy this, simply move the transmitter or receiver a few inches electrical interference • caused by the unintentional generation of rf due to an electrical spark, a...

  • Page 19

    Www.Diysecurity.Co.Za 13 possible sources of electrical interference: • tv or computer cathode ray tube (crt) displays • electric welders • air conditioners • continue on following page..... • brush-type motors • electrical interference • relays and switches of all kinds • arcing and corona discharg...

  • Page 20

    Www.Diysecurity.Co.Za 14 refraction • occurs when an rf wave crosses a boundary from one medium to another (i.E. From air to water). A wave entering a medium at an angle will change direction • diffraction: it is the bending of rf waves around an object’s edge, such as a sharp corner or opening • ob...

  • Page 21

    Www.Diysecurity.Co.Za 15 contact details tel: 011 462 7610 mobile: +27 (82) 903 7156 email: info@diysecurity.Co.Za website: www.Diysecurity.Co.Za diysecurity.Co.Za.