Magenta MultiView 500A Quick Reference & Setup Manual - page 9
.
CHAPTER 3: Setup and Installation
3.3 Configuration Settings
The MultiView™ 500 receiver is configurable for various video, audio and serial modes
depending upon model . Note that a compatible transmitter unit must be used at the
source end. Reference the appropriate transmitter user guide or call for technical
assistance. It is not possible to change an audio unit to a serial unit and vice versa.
A dipswitch on the receiver unit is used to set the video, audio, serial configuration
mode. Table 3-1 below shows the configuration settings (ON = down, OFF = up):
NOTE:
There are no user serviceable parts inside the MultiView 500 receiver. All
adjustments are performed externally.
Table 3-1. MultiView 500 Receiver Configuration Settings.
3.4 Video Adjustment
The only adjustments required on the MultiView 500 receiver are the SW positions 4
and 5 which must be set to compensate for cable length. Using the table below as a
guide, turn SW positions ON or OFF for best picture clarity (ON = down, OFF = up):
Table 3-2. Cable Length EQ Settings.
Cable distance EQ settings
Cable Length
4
5
(0-125 Ft)
OFF
OFF
(125-250 Ft)
ON
OFF
(250-375 Ft)
OFF
ON
(375-500 Ft)
ON
ON
SW Configuration Settings
SW position
1
2
3
Signal
Setting
L/R Audio
On (100
Ω term.)
ON
ON
500A models
On (no term.)
OFF
ON
Off
OFF
OFF
Serial
Duplex
OFF
OFF
500S models
Simplex
ON
OFF
Video
RGBHV
ON
All Models
Composite
OFF
S-Video
OFF
Component
OFF
7