Magewell XI006AUSB User Manual - 7.3.1 Capture
Copyright © 2009-2010 All Rights Reserved. Nanjing Magewell Electronics Co., Ltd.
7/16
7.3.1 Capture
Input interface: types of input interfaces are CVBS, because of only one interface
type, no need to select the input interface manually.
Signal status: Display the relevant parameters of signal source, for example the total
amount of rows, FPS (p is progressive scanning, i is Interlace Scanning)
7.3.2 Image Processing
Generically, default value need not adjust, but in different environments if image
brightness, color, noise cannot reach best, you should adjust manually to achieve best,
you can save the preset, then you can apply preset values without adjustment when
the same signal accesses.
Image Clipping: by adjusting image width, height, left margin and top margin to
achieve desired requirement. Increasing/reducing width of image starts from right,
Increasing/reducing height of image starts from bottom.
Skills of image clipping as follows:
1. Set scale “fill output image” to confirm whether clipping adjustment is
appropriate.
2. Cut off image left: firstly increase left margin, then reduce image width.
3. Cut off image right: reduce image width.
4. Cut off image top: firstly reduce image height, and then increase top margin.
5. Cut off image bottom: reduce image height.
After image adjustment completes, click "Save Preset" to save current adjustment;
click "Del preset" to delete preset you saved; click "Apply Preset" to apply the saved
preset to current settings.
7.3.3 Image Output
Display output format of current image, set image zoom scale, de-interlace and