Magic Chef 7858XRA Use And Care Manual - Electronic Controller
-4-
ELECTRONIC CONTROLLER
CLOCK
1. Press CLOCK.
2. Turn SET knob until display shows
correct time of day.
3. Press STOP/CLEAR.
When power is first supplied to oven
or if there has been a power failure,
the display will flash. Follow above in-
structions to set clock.
CLEAN
1. Close door.
2. Move door lock lever to locked po-
sition.
3. Press CLEAN pad. (“door” will
flash in display and beeps will
sound if door is not locked.)
4. Oven will automatically clean for 3
hours. Select 2 or 4 hours by turn-
ing the SET knob.
See pages 17 - 18 for additional infor-
mation.
BROIL
1. Press BROIL.
2. Turn SET knob clockwise to select
HI broil or counter clockwise to se-
lect LO broil.
See page 12 for additional informa-
tion.
TIMER
1. Press TIMER.
2. Turn SET knob to desired time.
TIMER starts automatically. 3 beeps
signal the end of the timing operation
and the time-of-day reappears in the
display.
To cancel:
Press TIMER and hold for
3 seconds. Time of day will reappear
after a slight delay.
COOK TIME/STOP TIME
To begin cooking immediately:
1. Press BAKE TEMP. Enter oven
temperature with SET knob.
2. Press COOK TIME. Enter desired
cooking time by turning the SET
knob.
To delay the start of cooking:
1. Press BAKE TEMP. Enter oven
temperature with SET knob.
2. Press COOK TIME. Enter cooking
time with SET knob.
3. Press STOP TIME. Enter time you
wish food to stop cooking with SET
knob.
The oven will automatically turn on
and off at the preset times.
Press STOP/CLEAR to cancel end-
of-cooking beeps. See pages 13 - 14
for additional information.
BAKE TEMP
1. Press BAKE TEMP.
2. Turn SET knob until desired oven
temperature appears in the dis-
play.
See pages 10 - 11 for additional infor-
mation on baking and roasting.
ADDITIONAL INFORMATION
A beep sounds each time a pad is
pressed. Three beeps signal the end
of an operation.
If a fault code (ex: F 2) is displayed
and beeps sound, press STOP/
CLEAR if fault code continues, see
pages 20 and 21.
Function pads on some models are
round - they operate as described in
this booklet.
TO CANCEL AN OPERATION:
Press STOP/CLEAR to cancel a cook
or clean operation.
HR
SET CLEAN COOK STOP TIMER
CLEAN
DELAY
BROIL
TIMED
LOCK
BAKE
ON
(NOTE: All indicator words are displayed to show their location. When oven or timer is not in
use, indicator words are not displayed. Indicators are only displayed when oven is set for a
cook, delayed cook, clean or timer operation.)