1. DL manuals
  2. Magic Chef
  3. Ranges
  4. CER3725AGW
  5. Service

Magic Chef CER3725AGW Service

Manual is about: Freestanding Electric Range Export

Summary of CER3725AGW

  • Page 1

    Cer3725agw cer4351agw 16026839 replaces 16026308 january 2006 © 2006 maytag services freestanding electric range export this base manual covers general information refer to individual technical sheet for information on specific models this manual includes, but is not limited to the following: servic...

  • Page 2: Warning

    2 16026839 © 2006 maytag services pride and workmanship go into every product to provide our customers with quality products. It is possible, however, that during its lifetime a product may require service. Products should be serviced only by a qualified service technician who is familiar with the s...

  • Page 3: Table of Contents

    © 2006 maytag services 16026839 3 table of contents important information ................................................... 2 important safety information safety practices for servicer .................................... 4 servicing ...................................................................

  • Page 4: W A R N In G

    4 16026839 © 2006 maytag services w a r n in g ! In case of fire fires can occur as a result of over cooking or excessive grease. Though a fire is unlikely, proceed as follows: surface element fires 1. Smother fire with a nonflammable lid/baking soda, or use a class abc or bc extinguisher. Not water...

  • Page 5: Caution

    © 2006 maytag services 16026839 5 electrical requirements 400/230–volt, 3–phase, 50/60 hertz, 16 amp per phase, individual circuit which is properly grounded, polarized and protected by a circuit breaker or fuse. Extension cord due to possible pinching during installation, extension cords should not...

  • Page 6: Important Safety Information

    6 16026839 © 2006 maytag services surface cooking units 1. Use proper pan size—this appliance is equipped with one or more surface units of different size. Select utensils having flat bottoms large enough to cover the surface unit heating element. The use of undersized utensils will expose a portion...

  • Page 7: General Information

    © 2006 maytag services 16026839 7 this manual contains information needed by authorized service technicians to install and service electric ranges. There may be, however, some parts which need further explanation. Refer to the installation instructions, use and care, technical sheets or the toll-fre...

  • Page 8: General Information

    8 16026839 © 2006 maytag services specifications refer to individual technical sheet for specification information. Placement of the oven this freestanding range must be placed in the kitchen or comparable room. All safety guidelines must be followed and free air flow around the range is essential. ...

  • Page 9: Range Description

    © 2006 maytag services 16026839 9 range description light switch clock infinite switches surface elements surface indicator lights serial plate oven door door handle oven racks broil element bake element service drawer door hinges infinite switches surface elements.

  • Page 10: Troubleshooting Procedures

    Troubleshooting procedures ! Warning to avoid risk of electrical shock, personal injury, or death, disconnect power to range before servicing, unless testing requires power. 10 16026839 © 2006 maytag services problem possible cause correction no bake element operation open bake element.................

  • Page 11: Troubleshooting Procedures

    Troubleshooting procedures ! Warning to avoid risk of electrical shock, personal injury, or death, disconnect power to range before servicing, unless testing requires power. © 2006 maytag services 16026839 11 problem possible cause correction surface element does not heat open element .................

  • Page 12: Component Testing Procedures

    Component testing procedures ! Warning to avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless testing requires power. 12 16026839 © 2006 maytag services illustration component test procedure results oven light socket remove one wire from recep...

  • Page 13: Component Testing Procedures

    Component testing procedures ! Warning to avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless testing requires power. © 2006 maytag services 16026839 13 illustration component test procedure results nsc controlled oven temperature adjustment p...

  • Page 14: Component Testing Procedures

    Component testing procedures ! Warning to avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless testing requires power. 14 16026839 © 2006 maytag services "quick test" mode for non-self clean control follow procedure below to use the quick test ...

  • Page 15: Component Testing Procedures

    Component testing procedures ! Warning to avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless testing requires power. © 2006 maytag services 16026839 15 diagnostic code checking code description when checked detection 1c1c shorted key always 1...

  • Page 16: Warning

    16 16026839 © 2006 maytag services warning ! To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing, unless testing requires power. Disassembly procedures infinite switch 1. Remove control panel, see "control panel" procedure for removal. 2. Label and ...

  • Page 17: Warning

    © 2006 maytag services 16026839 17 warning ! To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing, unless testing requires power. Disassembly procedures 4. Remove screws securing lower rear galvanized cover from unit. 5. Remove screws securing top an...

  • Page 18: Warning

    18 16026839 © 2006 maytag services warning ! To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing, unless testing requires power. Disassembly procedures oven light assembly oven light bulb/oven light socket 1. Remove power from unit (at the circuit b...

  • Page 19: Appendix  A

    © 2006 maytag services 16026839 a – 1 appendix a.

  • Page 20: Installation Instructions

    A – 2 16026839 © 2006 maytag services installation instructions your range may not be equipped with some of the features referred to in this manual. 8101p726-60 (12-05-00) clearance dimensions for complete information in regard to installation of a freestanding range, see figures i and 2 on page 2. ...

  • Page 21: Installation Instructions

    © 2006 maytag services 16026839 a – 3 installation instructions installation drawings -2- “a” = 30” (76.2 cm) - 31” (78.7 cm) for canada “b” = 7” (17.8 cm) - 7 1/2” (19.1 cm) for canada figure 2 “b” “a” cabinet openings, upper & lower provide for 400/230 volt three phase outlet per applicable cord i...

  • Page 22: Installation Instructions

    A – 4 16026839 © 2006 maytag services installation instructions -3- warning: a risk of range tip over exists if the appliance is not installed in accordance with the installation instructions provided. The proper use of this device minimizes the risk of tip-over. In using this device, the consumer m...

  • Page 23: Installation Instructions

    © 2006 maytag services 16026839 a – 5 installation instructions -4- connecting the range figure 6 hex nut holder electric supply the range must be installed in accordance with local codes or the us national electric code (nec) ansi/nfpa no. 70-latest edition. See the rating plate for the total conne...

  • Page 24: Installation Instructions

    A – 6 16026839 © 2006 maytag services installation instructions -5- connecting the range continued: conduit plate: for use with a cord skip figures 7 and 8. For use with conduit, remove the screws and remove the plate (see figure 7). Position the plate for conduit and reattach (see figure 8). Five w...

  • Page 25: Installation Instructions

    © 2006 maytag services 16026839 a – 7 installation instructions -6- connecting the range continued: bare wire connection: for a bare wire connection, attach the lugs (see figure 12). Use the proper torque (see the bare wire torque chart). Pull the service cord through (see figure 13). The earth wire...

  • Page 26: Installation Instructions

    A – 8 16026839 © 2006 maytag services installation instructions -7- figure 19 figure 16 figure 18 figure 17 service- parts information when your range requires service or replacement parts, contact your dealer or authorized service agency. Please give the complete model and serial numbers of the ran...

  • Page 27: Appendix  B

    © 2006 maytag services 16026839 b – 1 appendix b.

  • Page 28: Use and Care Instructions

    B – 2 16026839 © 2006 maytag services use and care instructions u ser ’ s g uide u ser ’ s g uide electric smoothtop range cer3725agw.

  • Page 29: Use and Care Instructions

    © 2006 maytag services 16026839 b – 3 use and care instructions notes: • sabbath mode can be turned on at any time with or without the oven on. • sabbath mode cannot be turned on if the touchpads are locked out or when the door is locked. • if the oven is baking when sabbath mode is set, “bake” will...

  • Page 30: Use and Care Instructions

    B – 4 16026839 © 2006 maytag services use and care instructions canning and oversize cookware all canners and large pots must have flat bottoms and must be made from heavy-gauge materials. This is critical on smoothtop surfaces. The base must not be more than 1 inch larger than the element. When can...

  • Page 31: Use and Care Instructions

    © 2006 maytag services 16026839 b – 5 use and care instructions • if desired, press the bake or broil pads and the current temperature setting will briefly reappear in the display during a timing operation. To cancel the timer operation: press and hold the timer pad for several seconds. Baking, roas...

  • Page 32: Cleaning Procedures

    B – 6 16026839 © 2006 maytag services care and cleaning instructions part procedure caution cleaning procedures • be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns. • to prevent staining or discoloration, clean appliance after eac...

  • Page 33

    © 2006 maytag services 16026839 b – 7 care and cleaning instructions * brand names for cleaning products are registered trademarks of the respective manufacturers. Part procedure oven window - • avoid using excessive amounts of water which may seep under or behind glass causing staining. Glass • was...