Magic Chef KLFP6B User Manual - page 10
AFTER SALES SUPPORT
888 775 0202 cshelp@mcappliance.com
44295-13
10
2. Place the bowl on the base unit
over the center stem as shown
and twist it clockwise to snap it
into the locked position. (Fig. A)
3. Place the blade assembly (blade
end down) or the disc holder
with either the shredding disc
or slicing disc securely in place
onto the center stem of the
base unit/bowl. Turn the blade
assembly or disc holder until it
drops securely in place. (Fig. B)
4. To change the disc in the disc
holder, turn the disc holder
upside down, as shown, and
push firmly against the right
side of the disc until the disc
pops out. (Fig.C)
5. When placing a new disc into the
disc holder, the disc holder should
be right side up. Insert the right
side of the disc, as shown, and
push firmly on the left side until
the disc pops into place. (Fig. D)
6. Place the cover on the bowl
either over the blade assembly
or disc holder. Twist clockwise to
snap it into the locked position
with the base unit. (Fig. E)
NOTE: There are arrows on
the bowl and the cover that
will help you line up the cover
properly.
7. The food processor is now ready for use.
NOTE: The food processor has an interlock mechanism that will not allow the base unit
to run if the bowl and the cover are not properly locked into the base unit.
a. Blade Assembly Setup
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
b. Disc Holder Setup