1. DL manuals
  2. Magic Chef
  3. Refrigerator
  4. MCKC490B
  5. User Manual

Magic Chef MCKC490B User Manual

Manual is about: User Manual

Summary of MCKC490B

  • Page 1

    1 4.9 cu.Ft. Beer keg cooler instruction manual model no.: mckc490b to ensure proper use of this appliance and your safety, please read the following instructions completely before operating this appliance..

  • Page 2: Table Of Contents

    2 table of contents names of the parts _________________________________________________3 important safety instructions ________________________________________ 4 installation instructions _____________________________________________ 4 before using your beer dispenser ______________________________...

  • Page 3: Names Of The Parts

    3 names of the parts model no.: mckc490b 1 beer tower 2 plastic gasket 3 safety guard rail 4 drip tray 5 adjustable thermostat 6 co 2 regulator 7 co 2 gas cylinder 8 co 2 gas cylinder support 9 evaporator 10 reversible door 11 beer keg (not included) 12 metal plate 13 metal washers(2) 14 castors wit...

  • Page 4: Installation Instructions

    4 important safety instructions warning to reduce the risk of fire, electrical shock, or injury when using your beer dispenser, follow these basic precautions: • read all instructions before using the unit. • warning: risk of child entrapment. • to avoid the possibility of child entrapment, please t...

  • Page 5

    5 radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the beer dispenser not to perform properly. This unit is not designed for outside installation (ie garages, porches, etc.) • avoid ...

  • Page 6

    6 installation instructions for beer keg keg installation sketch · install the four castors with lock provided into the unit’s bottom (four screw holes pre-supplied) the two metal gaskets are used for the front two castors. Figure (1) before installation. Figure (ii) is the final version. (i) (ii) m...

  • Page 7

    7 installation of co 2 cylinder support • install the metal support provided onto the 4 studs located on the exterior back wall. Align the holes in the support with the studs and push down firmly. (see figure 1) installation of co 2 cylinder • the co 2 cylinder does not come filled. The cylinder mus...

  • Page 8

    8 installation of the beer keg • position the beer keg directly in front of the open door. Using keg handles only, carefully lift the beer keg. (see figure 5) • to place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift the front of the keg just enough so the front edge of ...

  • Page 9: Dispensing Of Beer

    9 spanner faucet wrench spanner faucet wrench is provided for either removing or tightening connection plastic faucet lever attach the black plastic lever (pull handle) to the top of the faucet by tightening it by hand clockwise until the end, holding in the silver nut underneath so it does not turn...

  • Page 10

    10 operating your beer dispenser setting the temperature to start, turn the temperature control knob to the maximum setting (6). Allow the unit to run for 24 hours for the unit to cool properly. You may then adjust the temperature to the desired setting. In average room conditions of 70°f (21 ºc), s...

  • Page 11

    11 changing the reversible door this beer dispenser has a door that can be set to open from the left or right side. The unit is delivered to you with the door opening from the left side. To reverse the opening direction, please follow the instructions below. Caution: to avoid personal injury to your...

  • Page 12: Care And Maintenance

    12 care and maintenance cleaning your beer dispenser • turn the temperature control to "off", unplug the beer dispenser, and remove the contents. • wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. • wa...

  • Page 13: Troubleshooting Guide

    13 troubleshooting guide you can solve many common beer dispenser problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Problem possible cause beer dispenser does not operate. Not plugged in. The ci...

  • Page 14: Warranty

    14 warranty mc appliance corporation warrants each new beer keg cooler to be free from defects in material and workmanship and agrees to remedy any such defect or to furnish a new part(s) (at the company’s option) for any part(s) of the unit that has failed during the warranty period. Parts and labo...