Magic-pac MHP4 Series Installation And Maintenance Instructions Manual - page 4
Page 4 of 18
506325-01
Issue 0941
Installing and Securing Unit to Wall Sleeve
1.
Make sure the gaskets attached to the sleeve are not
damaged.
2.
Verify divider panel is positioned properly. Figure 3 shows
the correct position for 48" and 56" tall units (flange
Wall Sleeve and Louver Grille Installation
Refer to installation instructions included with the wall sleeve
kit and the louver grille kit along with Figure 2 for guidance in
assembling and installing the wall sleeve and louver grille.
pointing up). For 43" tall units, the divider panel should
be positioned so the flange points down.
3.
Place MHP4 unit into wall sleeve.
Lift leading end of
unit and walk unit onto sleeve.
Once in sleeve, lower
the unit into position. This prevents damage to the base
pads. Assure that the unit is level and completely seated
against the gaskets on the wall sleeve.
4.
Use the two installation brackets to secure the unit to
the wall sleeve (see Figure 4). The units are shipped
with the brackets placed in the return air compartment.
Hook each bracket into the front edge of the wall sleeve
side. Position the bracket so it can be bent around the
front corner of the unit. Remove one of the two screws
in that position on the unit. Line up one of the holes in
the installation bracket with the screw hole and attach
the bracket to the unit with that screw. Make sure to
fasten tight enough that the seal is maintained. Trim off
excess bracket if applicable.
Figure 2
Wall Sleeve and Louver Kit Installed
NOTE:
Platform must be
constructed so that it
is level with sill plate of
wall opening.
The sleeve is not intended as the sole support for the
unit. An additional support must be provided for
adequate support (see Figure 2).
CAUTION