Magicard Rio 2 Supplementary Manual
Ultra Electronics Card Systems
Page 1 of 3
www.magicard.com
August
2006
Custom Key Data Form
For Rio 2, Tango 2, Rio 2e, Tango 2e & Tango +L
This form is used to specify the Custom Key for your Rio 2,
Tango 2, Rio 2e, Tango 2e or Tango +L ID card printer.
The Custom Key is the memory card device that :
•
Holds your HoloKote watermark custom design.
•
Can also be used as a Locking Key for your printer.
CONTACT INFORMATION
DEALER CUSTOMER
Dealer _________________________
Contact ________________________
Phone _________________________
Email __________________________
P.O. # _________________________
Customer _______________________
Contact ________________________
Phone _________________________
Email __________________________
ORDER INFORMATION
Order quantity _________________
Signature ________________________
Custom Key function (tick one or both) :
HoloKote custom design
□
Locking key
□
New Key
□
Repeat Key
□
Original key serial # ________________
How will the logo be used?
Printed over entire card surface
□
Used only in one position
□
(mark one position on grid below)
How is the logo data being supplied?
Email (preferred method)
□
CD
□
Mark only one position on this grid.
Note : You do not need to specify the orientation (landscape or portrait) of the HoloKote logo as
the Rio 2 / Tango 2 driver allows you to choose either orientation in the driver user interface.