1. DL manuals
  2. Magikitch'n
  3. Griddle
  4. MKGD24
  5. Installation & Operation Manual

Magikitch'n MKGD24 Installation & Operation Manual

Manual is about: Griddle

Summary of MKGD24

  • Page 1

    L25-054 rev. 0 (01/12) installation & operation manual mkgd24, mkgd36, mkgd48, mkgd60 & mkgd72 all options d e i f i t r e c d e s i g n c i r e t i f e d important for future reference please complete this information and retain this manual for the life of the equipment: model #: __________________...

  • Page 2

    To the purchaser, owner and store manager please review these warnings prior to posting them in a prominent location for reference. L25-054 rev. 1 (01/12) 2 for your safety do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Warning impr...

  • Page 3

    Table of contents mkh series gas griddle l25-054 rev. 1 (01/12) 3 1. Installation section.......................................................................................4 1.1. C hecking y our n ew g riddle ..........................................................................................

  • Page 4

    Installation mkgd series gas griddle l25-054 rev. 0 (01/12) 4 caution connecting the appliance to an electrical supply other than that indicated on the data plate. May damage the appliance and void the warranty. Warning the electrical connection used by this appliance must comply with local codes. I...

  • Page 5

    Installation mkgd series gas griddle l25-054 rev. 1 (01/12) 5 location combustible construction inches (centimeters) non-combustible construction inches (centimeters) cabinet back 8.0 (20.4) 8.0 (20.4) cabinet sides 2.0 (5.0) 0.0 (0.0) 1.3. Installation clearances your new magikitch’n griddle needs ...

  • Page 6

    Installation mkgd series gas griddle l25-054 rev. 0 (01/12) 6 figure 2 figure 3 1.6. Installation setup the installation of this appliance must conform to local codes. In the absence of local codes the gas line must be installed to meet the local building codes or national fuel gas code ansi z223.1/...

  • Page 7

    Installation mkgd series gas griddle l25-054 rev. 1 (01/12) 7 1/2" bolts (4) bracket (2) mount flush to front (supplied) (supplied) nuts & bolts included with stand rear figure 4 notice larger models have 6 threaded receiving holes, but require only the four 1/2" bolts on each corner to mount the gr...

  • Page 8

    Installation mkgd series gas griddle l25-054 rev. 1 (01/12) 8 1.7. Final gas connection a properly installed gas supply system will deliver adequate pressure (7 to 8 inches w.C. For natural gas, 11 to 12 inches w.C. For propane) to all appliances connected to the line, operating at full demand. 1.7....

  • Page 9

    Operations mkgd series gas griddle l25-054 rev. 1 (01/12) 9 2. Operation section ensure that a proper installation has been performed on the appliance and that all warnings, cautions, and notices contained in this manual have been read, understood and adhered to before proceeding. 2.1. Lighting inst...

  • Page 10

    Operations mkgd series gas griddle l25-054 rev. 1 (01/12) 10 seasoning is not required on a chrome plated cooking surface, but the following procedure may be performed to improve the non-stick qualities of the chrome plated cooking surface. 2.2.1. Griddle surface seasoning 1. To season the griddle, ...

  • Page 11

    Calibration mkgd series gas griddle l25-054 rev. 1 (01/12) 11 22 0 1 40 22 0 1 40 250 20 0 1 50 °c °f 250 20 0 1 00 80 120 550 260 50 0 28 0 240 450 550 1 50 °c °f 1 00 80 120 50 0 260 28 0 cap line 240 450 1 60 30 0 350 1 80 400 200 350 1 80 30 0 1 60 400 200 5/16" nut aligned with actual temp. Tem...

  • Page 12

    Basic operation mkgd series gas griddle l25-054 rev. 1 (01/12) 12 4. Basic operation 4.1. Operational helpful hints 1. Each thermostat controls 12" of griddle surface, whenever possible, use the leftmost or rightmost thermostats for the lowest cooking temperatures. The adjacent thermostats set at hi...

  • Page 13

    Cleaning & maintenance mkgd series gas griddle l25-054 rev. 1 (01/12) 13 5. Cleaning & maintenance section 5.1. Griddle surface cleaning, during operation hours 1. Keep the griddle surface clean to prevent sticking and poor food product quality. 2. Scrape the griddle plate regularly through out the ...

  • Page 14

    Cleaning & maintenance mkgd series gas griddle l25-054 rev. 1 (01/12) 14 ü visually check the appearance of the main burners, all burners should have a nice blue flame. ü make sure that all gas connections have not been tampered with or damaged, check for leaks with a soapy water solution. Never use...

  • Page 15

    Trouble shooting mkgd series gas griddle l25-054 rev. 1 (01/12) 15 possible cause heat set too high moisture in food turning to steam griddle surface dirty or un-seasoned cooking times too short product shelf life expired improperly stored product excessive oil or grease on griddle surface heat set ...

  • Page 16: Surface

    Accessories mkgd series gas griddle l25-054 rev. 1 (01/12) 16 6. Accessories 6.1. Standard all plain steel and chrome plated griddles are shipped with a set of 4” adjustable legs. The appliance also comes equipped from the factory with a manual gas shutoff valve, and the specified gas regulator for ...

  • Page 17

    Accessories mkgd series gas griddle l25-054 rev. 1 (01/12) 17 towel bar only cutting boards are available on larger workshelves workshelves with and without towel bars pan cutouts and 6.2.2. Cutting boards other sizes are available, consult factory for size, price, and availability. Size part no. 8"...

  • Page 18

    Accessories mkgd series gas griddle l25-054 rev. 1 (01/12) 18 6.2.3. Warming shelves, rear shelf kits can be attached to existing models. The stainless steel shelf is removable from the shelf framework for easier cleaning if necessary. Shelf model part no. C/a, shelf rear mkg24 5225-1535701-c c/a, s...

  • Page 19

    Accessories mkgd series gas griddle l25-054 rev. 1 (01/12) 19 vvvv 6.2.4. Equipment stands equipment stands can be ordered with legs or casters (stands with casters shipped after may 2006 are equipped with adjustable casters). Note: it should also be noted that when ordering an equipment stand for y...

  • Page 20

    Accessories mkgd series gas griddle l25-054 rev. 1 (01/12) 20 6.2.5. Miscellaneous your appliance can also be used with the following miscellaneous accessories so you can customize your operation to your specific demands.. The wall spacers listed below insure that you cannot push the appliance too c...

  • Page 21

    Notes mkgd series gas griddle l25-054 rev. 1 (01/12) 21 7. Notes page.

  • Page 22

    L25-054 rev. 0 (01/12) in the event of problems with or questions about your order, please contact the magikitch’n factory at: ph- (603) 225-6684 world wide website- www.Magikitchn.Com in the event of problems with or questions about your equipment, please contact the magikitch’n authorized service ...