Magnavox \ Manual - page 6
9
10
Timer operation
1. Press the TIMER ON button. The remote
control shows the previous Auto-on setting
time and the symbol "h" on the LCD display.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
the time increases in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER ON ,there will be a slight
delay before the remote control transmits the
signal to the air conditioner. Then, after approximately
2 seconds, the symbol "h" will disappear and
the set temperature will show on the LCD display.
To set the Auto-on time.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
control shows the previous Auto-off setting
time and the symbol "h" on the LCD display.
2. Push the TIMER OFF button again to set desired
Auto-off time. Each time you press the button,
the time increases in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER OFF, there will be a
slight delay before the remote control transmits
the signal to the air conditioner. Then, after
approximately 2 seconds, the symbol "h" will
disappear and the set temperature will show
on the LCD display.
The effective operation time set by the remote control for the timer
function is limited to the following settings: 0.5, 1.0, 1.5, 2.0, 2.5, 3.0,
3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13,
14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24.
IMPORTANT
Example of Timer setting
TIMER ON
Start
Off
6 hours later
(Auto-on Operation)
The TIMER ON feature is useful when you want
the unit to turn on automatically. The air conditioner
will automatically start operating at the set time.
To start the air conditioner in 6 hours.
1. Press the TIMER ON button, the last setting of
starting operation time and the symbol "h" will
show on the display.
2. Press the TIMER ON button to display "6:0h" on
the TIMER ON display of the remote control.
3. Wait for about 3 seconds and the digital display
area will show the temperature again. This shows
that the function is activated.
TIMER ON
Example:
h
Set
1
2
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
SWING
TIMER ON
ECONOMY
ON/OFF
TIMER OFF
RESET LOCK
SET TEMPERATURE( C)
LED
DISPLAY
TIMER ON