1. DL manuals
  2. Magnavox
  3. Air Conditioner
  4. P-08PE
  5. Owner's Manual

Magnavox P-08PE Owner's Manual

Summary of P-08PE

  • Page 1

    Before operating this product, please read the instructions carefully and save this manual for future use. Model: p-14pe for any service needs, call 1-855-368-8606 owner's manual.

  • Page 2

    Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner. You'll find many answers to common problems in the troubleshooting tips sect...

  • Page 3: Contents

    1 contents safety precautions safety rules .. . .....................................................................................................................................2 operating conditions ...................................................................................................

  • Page 4

    To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation may cause harm or damage. Your air conditioner should be protected from moisture. E.G. Condensation, splashed water, etc. Do not place or store your air conditioner whe...

  • Page 5

    Be sure the power requirement is adequate for the model you have chosen. This information can be found on the serial plate, which is located on the side of the cabinet and behind the grille. Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper grounding is imp...

  • Page 6

    Parts identification name of parts fig.2 front control panel horizontal louver blade (swings automatically) caster wheels carrying handles (on each side) 1 2 3 4 1 2 3 4 1 2 3 4 5 model a model b control panel horizontal louver blade (operate manually) remote signal receptor caster wheels carrying h...

  • Page 7

    Air conditioner features before you begin, thoroughly familiarize yourself with the control panel and remote controller and all its functions, then follow the symbols for the functions you desire. The unit can be controlled by the unit control panel itself with the remote control. Electronic control...

  • Page 8

    Operating instructions press the ion button, to activate the ion generator which will help to remove pollen and impur ities from the air, and trap them in the filter. Press again to stop. 8 ion button(optional) operating instructions - press the "mode" button until the "cool" indicator light comes o...

  • Page 9

    Operating instructions other features after the unit has been turned off, it can not be restarted immediately. This is to protect the unit from malfunction. Operation will automatically 3 restart after minutes have passed. Wait 3 minutes before resuming operation the louver can be adjusted manually ...

  • Page 10

    Installation instructions installation instructions placement window slider kit installation note: if the window opening is less than the recom- m mended inimum length of the window slider kit, make a hole to fit the window opening. Never cut the hole out of the window slider kit. Fig.7 bolt window ...

  • Page 11

    Installation instructions installation in a double-hung sash window 1. Cut the foam seal(adhesive type) to the proper length and attach it to the window sill. Fig.10 2. Attach the window slider kit to the window silll. Adjust the length of the window slider kit according to the width of window, shor...

  • Page 12

    Installation instructions installation in a sliding sash window 1. Cut the foam seal(adhesive type) to the proper length and attach it to the window frame,fig.14. 2. Attach the window slider kit to the window sill. Adjust the length of the window slider kit according to the width of window, shorten ...

  • Page 13

    Installation instructions note: please seal the white foam seal (supplied) between the window kit and the window sill when there is the gap between them as shown below: window kit window sill (fig.A) gap window kit window sill (fig.A1) white foam seal seal the white foam seal window kit gap window f...

  • Page 14

    Installation instructions exhaust hose installation: the exhaust hose and adaptor must be attached or removed in accordance with the usage mode. The duct can be compressed or extended moderately according to the installation requirement, but it is desirable to keep the duct length to a minimum. 1. I...

  • Page 15

    Installation instructions water drainage: - during dehumidifying modes, remove the drain plug from the back of the unit, install the drain connector(5/8 universal female mender) with 3 4 hose(locally purchased). For the models without drain connector, just attach the drain hose to the hole. Place th...

  • Page 16

    Care and maintenance care and maintenance 1) be sure to unplug the unit before cleaning or servicing. 2) do not use gasoline, thinner or other chemicals to clean the unit. 3) do not wash the unit directly under a tap or using a hose. It may cause electrical danger. 4) if the power cord is damaged, i...

  • Page 17

    Troubleshooting tips trouble shooting 1. Unit does not start when pressing on/off button problem solution reset the temperature. Make sure all the windows and doors are closed. Remove the heat sources if possible. Connect the duct and make sure it can function properly. Decrease the set temperature....

  • Page 18

    Magnavox and smart. Very smart are registered trademarks of koninklijke philips n.V. And are used under license from koninklijke philips n.V..