Magnet PR-7 Operation Manual - page 5
4
Functions
1. POWER Pressing the POWER button once on the front panel will turn the machine on.
The LED on the front panel will light up when the machine in ON. The PR-7 will remain in
mute for approximately 4 sec after turning on to allow for component stabilization. The
power LED will be dimly lit while the machine is on MUTE. The LED will be fully lit when
the machine is out of mute and ready to play.
Press POWER again to turn the machine OFF. The LED will fade off when the power is off.
2.
BALANCE Turning the balance level will lower your output level left/right. Leaving it in
the center will give you equal output on both channels. Sometimes in unequal source
recording, you may need to adjust the balance level to get a balanced stereo image.
3.
TREBLE For adjustment of higher tone. Turning the TREBLE level will boost or cut the treble
level of your output . Leaving it in the center will give you a flat frequency response output.
4.
BASS For adjustment of lower tone. Turning the BASS level will boost or cut the bass
level of your output . Leaving it in the center will give you a flat frequency response output.
5.
TONE Press the TONE switch to activate TREBLE and BASS circuitry. When not engaged
( not pressed in) the signal will bypass the TONE circuitry.
6.
TAPE Press the Tape switch once to select TAPE input as the source. Press TAPE once more
to un-selected TAPE mode.
7.
VOLUME For adjustment of the output level.
8.
CD/TUNER/LASER/VIDEO/LINE1/LINE2 Turn the select knob to your desired source input.