Magnet sa-4 integrated amplifier operation manual magnet technology corporation room 509, 5th floor hi-fi center, patumwan, bangkok 10330 thailand tel: (6602)655-3526, (6602)655-3527 fax: (6602)655-3529 email: info@magnet.Co.Th.
1 important 1 the lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons . Caution: to preven...
2 preface thank you for purchasing the magnet sa-4 integrated amplifier. You have selected a component which has been designed to exacting standards to provide you with years of listening pleasure. It is important to remember that all magnet’s products can provide high quality sound, if you take pro...
3 5. Before connecting or disconnecting any cables, always turn off your equipment. 6. Before turning the power on/off, turn your volume control to the lowest output level. Connections note : make all connections to and disconnection from the sa-4 with ac power disconnected and all system components...
4 11. Ac power connect the sa-4 to an ac power source only of the type describe in these operating instruction or as marked on the rear panel of the unit. Make sure to have the proper power voltage rating to match with your sa-4. 12. Fuse replace only with same type of fuse as marked on the rear pan...
5 troubleshooting guide if the machine is not working properly please check the symptoms below and follow the corrective suggestion. If the problem still occurs, please contact our service department. Symptom remedy 1. Unit does not power up/no led on. - confirm ac is plugged in properly. - check if...
6 specifications line amplifier section frequency response (20-20,000hz) + 0.09, -0.03 db thd+noise @ 1 vrms (20-20,000hz) input impedance 50k ohms maximum gain 15.5 db signal / noise 98 db maximum output at 1k 7 vrms power amplifier section frequency response (20-20,000hz) +0. -0.09 db thd+noise (2...
