Magnetek MLTX Instruction Manual - page 7
Battery Charger Instruction Manual – October 2011
10
3. Once in place, both LEDs will illuminate (RED and GREEN),
indicating the battery is charging.
Figure3
4. When the battery is fully charged, only the GREEN LED will
be illuminated. The battery will be charged within 3 hours.
5. If an error has occurred with the charging process, the green
LED will turn off and the RED LED will be illuminated.
Remove the battery from the charger and try again (see
Table 1.0
for more troubleshooting instructions).
NOTE:
All new rechargeable battery packs must be charged
before usage.
Conditioning:
A new rechargeable battery pack may experience a
low usable capacity during the first few charge cycles due to long
storage. This is normal. Battery capacity will be restored after
several full charge/discharge cycles.
Red LED
Green LED
Battery Charger Instruction Manual – October 2011
7
WARNING
This manual includes instructions regarding the safe operation of
the Magnetek E10670/E10757/E10759 series of battery chargers.
If you ignore these instructions you are assuming responsibility for
damages, costs, or injury incurred by such disregard.
These battery chargers contain no customer serviceable parts.
Opening or tampering with the internal electronics will void the
manufacturer’s warranty.
Do not make any changes or modifications to the charger unit.
Failure to comply will void the manufacturer’s warranty.
Do not attempt to open a rechargeable battery pack. The pack has
been permanently sealed at the factory and contains no
serviceable parts. If the pack has been damaged in any way,
immediately cease use of the battery pack and dispose of it in
accordance with all applicable regulations.