Magnetrol ECHOTEL 940 Installation And Operating Manual - page 2
Front view
of gap
Wrench
flats are
aligned with
sensor gap
These units are in compliance with:
1.The EMC directive 2014/30/EU. The units have been
tested to EN 61326: 1997 + A1 + A2
2.The PED directive 2014/68/EU (pressure equipment
directive). Safety accessories per category IV module
H1.
2
UNPACKING
Unpack the instrument carefully. Make sure all components
have been removed from the foam protection. Inspect all
components for damage. Report any concealed damage to
the carrier within 24 hours. Check the contents of the car-
ton/crates against the packing slip and report any discrep-
ancies to Magnetrol. Check the nameplate model number to
be sure it agrees with the packing slip and purchase order.
Check and record the serial number for future reference
when ordering parts.
MOUNTING
Tri-Clamp
®
Gap indication
Model and
serial number
High alarm
High alarm
Low alarm
Filling line
Pump protection
Pump
Low alarm
Nozzle mounting: gap must be free
▼
▼
min.
25 mm
Threaded
Welded flange
0038