Summary of MSE-L24-HD
Page 1
Mse-l24-hd user's manual r model a.
Page 2: Table of Contents
Table of contents section 1: unpacking and set-up of system.................................. 2 section 2: features and operating instructions.............................4 turning on the system................................................................ 4 selecting viewing mode....................
Page 3: Osition The
Section 1: unpacking & set-up 1. Remove user’s manual and power cord from top foam compartments and remove the upper foam packaging. 2. Next, firmly grab hold of each side of camera unitand lift unit out of the foam packing in the bottom of the carton. Place camera system on sturdy desk or table whe...
Page 4: Set-Up (Cont’D)
3 set-up (cont’d) 5. Next, connect the monitor power cord on the rear panel of the camera. Note: the power supplied to the ac out jack turns on & off with the camera power switch. To the ac out jack 6. Finally, connect one end of the dvi signal cable to the monitor jack and the control cable to the ...
Page 5: Turning On The System
Section 2: features & instructions turning on the system selecting viewing mode turn the unit on using the power switch located under the front, right corner of the camera housing. The lighting should illuminate the viewing table. The screen should come on after a normal delay of several seconds. If...
Page 6: Adjusting Magnification
By pushing the mode control right or left you cycle through the viewing modes. In most cases, the full color hd modes works well for viewing pictures or color graphics while one of the black & white or select-a-color modes may perform better for reading or writing text. Once you have selected your p...
Page 7: Adjusting Brightness
6 adjusting brightness the brightness control is used to brighten or darken the image being viewed. Brightness can be readjusted whenever needed, in any mode. Turn the brightness control to the right to brighten the image turn to the left to darken when first learning to use the hd camera system, pl...
Page 8: Viewing Under The Camera.
7 the viewing table (sometimes referred to an x-y table) is mounted on a slide mechanism allowing it to move under the camera left to right and also front to back. This assists you in moving the material you are viewing under the camera. Using the viewing table magnification, the angle of lighting f...
Page 9
8 additional table features include: 1. Rear alignment edge on the table allows you to line up pages or envelopes. This is especially useful for writing. 2. Non-glare wipeable table surface reduces eyestrain. Its dark color and speckled pattern helps you to distinguish the edge of a white page. Usin...
Page 10: Section 3: Safety & Service
9 section 3: safety & service safety information and maintenance 1. Always put the viewing table in the locked position (brake lever to the far right) and use the hand holds in the base of the unit when attempting to move the machine. 2. Place unit on a sturdy table away from any heat source. Do not...
Page 11: Notes
10 service information (cont’d) in the event service is required, you may be asked to send the unit to magnisight’s main repair facility. The camera or system must be shipped in the original packaging to prevent damage. Please call magnisight for return information or to order packaging if needed. N...