1. DL manuals
  2. MagniSight
  3. Magnifiers
  4. MSE-L22 Explorer Classic
  5. User Manual

MagniSight MSE-L22 Explorer Classic User Manual

Summary of MSE-L22 Explorer Classic

  • Page 1

    Mse-l22 user's manual r.

  • Page 2: Table of Contents

    Table of contents section 1: unpacking and set-up of system.................................. 2 section 2: features and operating instructions.............................4 turning on the system................................................................ 4 selecting viewing mode....................

  • Page 3: Osition The

    Section 1: unpacking & set-up 1. Remove user’s manual and power cord from top foam compartments and remove the upper foam packaging. 2. Next, firmly grab hold of each side of camera unitand lift unit out of the foam packing in the bottom of the carton. Place camera system on sturdy desk or table whe...

  • Page 4: Set-Up (Cont’D)

    Dvi signal cable power cord (to wall outlet) monitor power cord 3 set-up (cont’d) 5. Next, connect the monitor power cord on the rear panel of the camera. Note: the power supplied to the ac out jack turns on & off with the camera power switch. To the ac out jack 6. Finally, connect the monitor signa...

  • Page 5: Turning On The System

    Section 2: features & instructions turning on the system selecting viewing mode turn the unit on using the power switch located on the right side of control panel of the camera housing. The lighting should illuminate the viewing table. The screen should come on after a normal delay of several second...

  • Page 6: Adjusting Magnification

    By pushing the mode control switch up or down you cycle through the viewing modes. In most cases, the full color mode works well for viewing pictures or color graphics while one of the black & white or modes may perform better for reading or writing text. Once you have selected your preferred viewin...

  • Page 7: Adjusting Contrast

    6 adjusting contrast the contrast control is used to brighten or darken the image being viewed. Contrast can be readjusted whenever needed, in any mode. Turn the contrast control to the right to brighten the image turn to the left to darken when first learning to use the camera system, place printed...

  • Page 8: Viewing Under The Camera.

    7 the viewing table (sometimes referred to an x-y table) is mounted on a slide mechanism allowing it to move under the camera left to right and also front to back. This assists you in moving the material you are viewing under the camera. Using the viewing table brake (to lock) moving the lever all t...

  • Page 9: Section 3: Safety & Service

    8 section 3: safety & service safety information and maintenance 1. Always put the viewing table in the locked position (brake lever to the far right) and use the hand holds in the base of the unit when attempting to move the machine. 2. Place unit on a sturdy table away from any heat source. Do not...

  • Page 10: Notes

    9 service information (cont’d) in the event service is required, you may be asked to send the unit to magnisight’s main repair facility. The camera or system must be shipped in the original packaging to prevent damage. Please call magnisight for return information or to order packaging if needed. No...