Magnum 2824 Owner's Manual

Manual is about: BUILD-IN FACTORY BUILT MASONRY FIREPLACE

Summary of 2824

  • Page 1

    Magnum masonry manual – may 1999 page - 1 - magnum ® build-in factory built masonry fireplace owners manual installation, operation and maintenance guide models 2824 – 2832st – 3224 – 3228 – 3528 – 3536st – 6028tv keep these instructions for future use warning read entire manual before installation ...

  • Page 2: Table of Contents

    Magnum masonry manual – may 1999 page - 2 - table of contents page.

  • Page 3

    Magnum masonry manual – may 1999 page - 3 - dear valued magnum customer, i would like to take this time to thank you personally for the purchase of your magnum fireplace. You have purchased a product that has over the past 30 years earned its reputation for unmatched quality and efficiency. The adde...

  • Page 4

    Magnum masonry manual – may 1999 page - 4 - safety first • consult your local building codes first. Failure to comply with these requirements can result in an installation being denied by the local building inspector. A non-combustible fireplace hearth extension must extend at least 16” in front and...

  • Page 5

    Magnum masonry manual – may 1999 page - 5 - important tips • do not allow the steel fireplace unit to come into immediate contact with masonry or mortar. • fiberglass insulation with paper removed should be used as a buffer between steel from fireplace and any masonry. • a lintel bar must be used to...

  • Page 6

    Magnum masonry manual – may 1999 page - 6 - caution: the magnum fireplace and its components have been tested for safety when installed in accordance with this installation manual. It is your responsibility to read all instructions carefully before and during the installation to assure safe operatio...

  • Page 7

    Magnum masonry manual – may 1999 page - 7 - • excavate a hole to conform to the frost level (approximately 48” deep in the northern climates). Allow the footing to be in excess of 6” beyond the area needed to install the unit. Note: if the unit is being installed on an existing slab, you need 12” of...

  • Page 8

    Magnum masonry manual – may 1999 page - 8 - • the ceiling height and the height of the flue extension determine the heat chamber height. The top vent must remain a minimum of 17” below the ceiling level. Note: if a wooden header is used above the top slab, 12” minimum of clearance is necessary. This...

  • Page 9

    Magnum masonry manual – may 1999 page - 9 - • a gas log lighter access can be provided for in the magnum-see-thru and magnum standard models. Important note: this is an access only and should be used only to bring the gas line through. Do not make a direct connection to the fireplace box or a fractu...

  • Page 10

    Magnum masonry manual – may 1999 page - 10 - tri-view (6028-tv) lintel iron installation • supplied with every magnum 6028-tv fireplace is a specially made lintel iron. This lintel iron is used to install the facing on the front of the fireplace. • take the two (2) 3/8” diameter rods out of the fire...

  • Page 11

    Magnum masonry manual – may 1999 page - 11 - • ducting the magnum to remote locations is not allowed. A cold air return positioned on the ceiling above the heat outlet grill as a rule would be the easiest. Caution: temperatures exceeding 400 will be common and cannot be handled by ordinary ductwork....

  • Page 12

    Magnum masonry manual – may 1999 page - 12 - model 2824 fireplace minimum footing slab 48” wide x 72” minimum height from floor to bottom fiberglass insulation of slab 64” lightweight block this height may vary with different installations air space around unit warning: do not pack required air spac...

  • Page 13

    Magnum masonry manual – may 1999 page - 13 - model 2824 arched series fireplace dimentional chart denotes foundation minimum dimensions and masonry facing applications. Note: footings must be 6” larger per side of area needed for fireplace enclosure. Footings must be a minimum of 12” thick. Note: in...

  • Page 14

    Magnum masonry manual – may 1999 page - 14 - model 3224 fireplace dimentional chart denotes foundation minimum dimensions and masonry facing applications. Note: footings must be 6” larger per side of area needed for fireplace enclosure. Footings must be a minimum of 12” thick. Note: installation dim...

  • Page 15

    Magnum masonry manual – may 1999 page - 15 - vertically adjacent installations (16” offset required).

  • Page 16

    Magnum masonry manual – may 1999 page - 16 - operation and maintenance tips congratulations! You are now ready to sit back, relax and admire the beautiful work! But before you use your fireplace, please read the following instructions for the best results. Before starting the first fire : note: the ...

  • Page 17

    Magnum masonry manual – may 1999 page - 17 - 7) when hot air flows from your heat output grill (approximately 40 minutes), you can start your fan. Remember, this fireplace is a good heat exchanger, so run your fan at a speed to maintain hot air at the heat outlet grill. By reducing the fan speed, yo...

  • Page 18

    Magnum masonry manual – may 1999 page - 18 - special notes • never completely close damper/combustion controls until you are certain that there are no warm embers or coals. • if a posi-seal shutoff is used (brass knob), make sure that this is closed (pushed in) when fireplace is not in use. Remember...

  • Page 19

    Magnum masonry manual – may 1999 page - 19 - • keep the glass doors clean. Dirty glass doors will heat unevenly and may break. Use a special cleaning solution available from your dealer to remove any stain that may accumulate on the glass. Clean doors only when cold. Do not use glass wax or any oil ...

  • Page 20

    Magnum masonry manual – may 1999 page - 20 - installation instructions parts list 1) spring handle sh-brass 5) expand pin 14 9) allen wrench 2) steel shank 127 6) steel shank 126 3) steel collar 2x-568 7) set screw 1420 4) spring 36100g 8) washer 12 - take fireplace door out of carton and remove pla...

  • Page 21

    Magnum masonry manual – may 1999 page - 21 - fuel tips burn only seasoned dry wood. Wood must be cut and stacked off the ground for at least six months before it starts to be considered seasoned. In choosing wood, watch for checking or cracking of wood starting at the center and radiating outward li...

  • Page 22: Fireplace

    Magnum masonry manual – may 1999 page - 22 - fireplace limited warranty and 25 year protection plan limited warranty this limited warranty will not become effective unless you have returned card within 30 days of purchase. If you fail to do so you may make no claim under this warranty. American ener...