Magnum Energy M-RC Owner's Manual - Mounting

© 

2010 Magnum Energy, Inc.

Mounting

The remote control panel can be fl ush mounted through an 

opening in a wall; or, if there is insuffi cient room behind the wall 

— or no desire to cut into the wall — the remote can be surface 

mounted. 

CAUTION: Always check for hidden electrical wires, 

pipes, and cables BEFORE drilling, cutting, or screwing 

into walls or cabinets.

Flush Mounting

To fl ush mount the remote, the unit’s display panel will need to be 

placed into an opening. This opening must have at least a 2” depth 

to allow room for the remote’s rear circuit board and cables. 

1. Cut an opening in a wall – see Figure 2 to determine the correct 

opening dimensions. DO NOT cut the opening too big to ensure 

there are no openings around the display, and that there is enough 

material for the screws to secure the display. Remove any wall 

insulation (if applicable) that may contact the back of the remote.

2. Route the communications cable from the inverter up into the 

opening in the wall. 

3. Connect the communications cable to the RJ11 jack at the rear 

of the remote control (see Figure 2). 

4. Position the remote into the opening in the wall.

5. Secure the remote to the wall with the 2 screws provided. 

6. After ensuring the inverter is OFF, plug the communications 

cable into the REMOTE port on the front of the inverter.

Figure 3, Flush Mounting

3

2.0 Installation

M IN  1 1/2"

M A X   1  5 /8 "

M IN   2 "

M A X  2  1/8 "

CUT THIS

AREA OUT

Communication Cable 

(routed in the wall)

BU L K

ABSO R B

FAU L T

FL O AT

AC  IN

IN VER T

O N/ O FF