Summary of MD 308
Page 1
Magnum dynalab md 308 integrated amplifier instruction manual.
Page 2
- 2 - table of contents a message from the president 3 unpacking your md 308 4 setting up the md 308 5 connecting speakers and powering the md 308 5 hooking up sources to the md 308 6 set up the md 308 with an external home theater processor 6 hooking up a subwoofer to your system 7 tape out loop 7 ...
Page 3
- 3 - a message from the president thank you for choosing the magnum dynalab md 308 integrated amplifier. Great care has been given in the design, manufacturing and selection of components for the md 308 integrated amplifier. This complete process insures optimum listening enjoyment for many years. ...
Page 4
- 4 - unpacking your md 308 carefully inspect all sides of the shipping carton for damage. If there are marks or holes in the carton make note of the location in relation to the unit inside. Any obvious dents or scuff marks should alert you to the possibility of damage. Carefully remove the md 308 f...
Page 5
- 5 - setting up the md 308 1. Position the receiver away from any spot which may have extremes in temperatures. 2. Place the receiver on a very rigid surface capable of holding 50 pounds (22 kg). 3. The heat sinks on the side of the unit are used to keep the unit at a safe operating temperature. It...
Page 6
- 6 - hooking up sources to the md 308 1. Using your rca cables, plug the other source into one of the inputs marked in the back of the md 308. 2. Set the input on the receiver to match the input on the rear of the unit that the other source is plugged into. 3. With volume set to zero, power up the ...
Page 7
- 7 - 6. Input a4 is now the dedicated input for you to listen and control volume with your home theater processor (meaning that when you listen to regular music you use the preamplifier found in the md 308). Once input a4 has been activated into home theater mode, volume on input a4 will now be con...
Page 8
- 8 - control & display functions 1. Left balance indicator: this will light up when you change the output balance of the amplifier. Note that the amount of deviation from center balance will be shown in db on the display. 2. Input indicator: when the md 308 is powered on, this led will be lit. 3. R...
Page 9
- 9 - rc8 remote control unpacking the remote: • remove the remote from its plastic bag, and install the 3 aa batteries provided • test the remote to make sure that all functions are operating correctly. Functions of the remote please note that the rc8 remote includes certain features which are not ...
Page 10
- 10 - troubleshooting problem possible cause possible solution no sound, meter lights are not on • power cord disconnected • power off at source • fuse blown • connect power cord • check ac source • check rear panel fuse no sound, meter lights are on • interconnect not properly installed • preamp s...
Page 11
- 11 - safety sheet important safety instructions 1. Keep these instructions 2. Heed all warnings 3. Follow all instructions 4. Do not use this apparatus in water 5. Clean only with dry cloth 6. Do not block any ventilation openings, install in accordance with the manufacturer’s instructions. 7. Do ...
Page 12
- 12 - limited warranty register your product at www.Magnumdynalab.Com magnum dynalab ltd. Herein referred to as the “manufacturer” guarantees this product to be free of defect in both material and workmanship and agrees to remedy any such defect or replace any defective component at no charge for a...