Summary of MD 309
Page 1
- 1 - magnum dynalab md 309 hybrid integrated amplifier instruction manual.
Page 2
- 2 - table of contents dear valued customer .............................................................................................. 3 unpacking your md 309 hybrid integrated amplifier ................................... 4 setting up the md 309 hybrid integrated amplifier .......................
Page 3
- 3 - dear valued customer thank you for choosing the magnum dynalab md 309 hybrid integrated amplifier . Great care has been given to the design, manufacturing and selection of components for the md 309 hybrid integrated amplifier . This complete process insures optimum listening enjoyment for many...
Page 4
- 4 - unpacking your md 309 hybrid integrated amplifier carefully inspect all sides of the shipping carton for damage. If there are marks or holes in the carton make note of the location in relation to the unit inside. Any obvious dents or scuff marks should alert you to the possibility of damage. C...
Page 5
- 5 - setting up the md 309 hybrid integrated amplifier 1. Position the unit away from any spot which may have extremes in temperatures. 2. Place the unit on a very rigid surface capable of holding 50 pounds (22 kg). 3. The heat sinks located inside the unit are used to keep the unit at a safe opera...
Page 6
- 6 -.
Page 7
- 7 - connecting additional sources to the md 309 hybrid integrated amplifier caution as standard practice, you should always turn off the main power to the md 309 hybrid integrated amplifier (found on the rear panel of the unit) whenever any source component, interconnect or loudspeaker is being ch...
Page 8
- 8 - 7. Hit the button marked “ssp” and then “save”. 8. When the screen goes back to the main screen it should now read ssp and the volume control will have no effect on the level. Hooking up a subwoofer to your system 1. Unplug the power cord to the md 309 hybrid integrated amplifier. 2. Using rca...
Page 9
- 9 - rc6 remote control unpacking the remote: • remove the remote from its plastic bag, and install the 2 “aa” batteries provided • test the remote to make sure that all functions are operating correctly. Functions of the rc6 remote 1. Power main: power on & off 2. Volume up/volume down: increase o...
Page 10
- 10 - image of rc6 remote.
Page 11
- 11 - control/display functions (numbers correspond with product diagram on page 11) 1. Input selector – changes the input source sequentially. 2. Left channel meter – indicates the volume level of the left channel in db. 3. Touchscreen display/power – the main display for the md 309 hybrid integra...
Page 12
- 12 - diagram of md 309 hybrid integrated amplifier.
Page 13
- 13 - trouble shooting problem possible cause possible solution no sound, meter lights are not on • power cord disconnected • power off at source • fuse blown • interconnect not properly installed • preamp set to wrong source • power amp off • connect power cord • check ac source • check rear panel...
Page 14
- 14 - specifications power output audio frequency response (+/-0.1db) signal to noise ratio total harmonic distortion class of operation input impedance output impedance after volume control inputs outputs output sensitivity fully balanced amplifier design safety diagnostic system dynamic headroom ...
Page 15
- 15 - safety sheet important safety instructions 1. Keep these instructions 2. Heed all warnings 3. Follow all instructions 4. Do not use this apparatus in water 5. Clean only with dry cloth 6. Do not block any ventilation openings, install in accordance with the manufacturer’s instructions. 7. Do ...
Page 16
- 16 - limited warranty register your product at www.Magnumdynalab.Com magnum dynalab ltd. Herein referred to as the “manufacturer” guarantees this product to be free of defect in both material and workmanship and agrees to remedy any such defect or replace any defective component at no charge for a...
Page 17
- 17 - to prevent fire shock or hazard, do not expose this appliance to rain or moisture. To reduce the risk of electric shock, do not remove cover or faceplate, no user serviceable parts inside. Refer servicing to qualified service personnel..