Submersible contractor pump msc 2101 • msc 2202 • msc 2302 msc 3202 • msc 3302 operating/parts manual.
2 introduction this manual provides information and procedures to safely operate and maintain the pump. For your own safety and protection from physical injury, carefully read, understand, and observe the safety instructions described in this manual. Keep a copy of this manual with the unit at all t...
3 table of contents page introduction ................................................................................................................................... 2 table of contents .................................................................................................................
4 this is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. This manual contains dangers, warnings, cautions, notices and notes which must be followed to prevent the possibility o...
5 unit serial number location refer to the location illustrated below to find the unit id tag. Important information, such as the unit serial number and model number are found on this tag. Record the information from this tag, so it is available if the tag is lost or damaged. When ordering parts or ...
6 specifications read this manual carefully before attempting to use this pump. The potential for property damage, personal injury or death exists if this equipment is misused or installed incorrectly. Magnum model msc 3202 msc 3302 motor type ................................................. 1 Ø, 6...
7 operating the pump 1. Connect the discharge hose with the proper fittings. 2. Place the pump in the water. Lower by attaching a strong rope to the handle. The pump should be placed on a flat, hard surface in at least 2 inches of water. Warning never lower or move the pump with the electrical cord....
8 handle discharge inlet impeller (under inlet) housing cord component locations - msc 2101, msc 2202 & msc 3202.
9 handle discharge inlet impeller (under inlet) housing component locations - msc 2302 & msc 3302.
10 1 2 3 6 7 8 9 11 10 12 13 14 15 16 17 18 4 5 unit assembly and parts - msc 2101, msc 2202 & msc 3202.
11 item no. Part no. Qty description notes 1 41618 1 handle 2 41612 1 power cord for msc 2202 & 3202 2 41611 1 power cord for msc 2101 3 41770 1 rubber gasket for msc 2202 & 3202 3 41769 1 rubber gasket for msc 2101 4 41720 1 base-capacitor 5 41636 1 upper bearing for msc 2202 & 3202 5 41635 1 upper...
12 1 2 3 6 7 8 9 11 10 12 13 14 15 16 17 18 4 5 unit assembly and parts - msc 2302 & msc 3302.
13 item no. Part no. Qty description notes 1 41620 1 handle 2 41613 1 power cord 3 41770 1 rubber gasket 4 41720 1 base-capacitor 5 41637 1 upper bearing 6 41626 1 capacitor - run 7 41667 1 capacitor - start 8 41732 1 impeller key 9 41644 1 lower bearing 10 41652 1 mechanical seal 11 41661 1 seal pl...
14 wiring diagram - msc 2101.
15 wiring diagram - msc 2202, msc 2302, msc 3202 & msc 3302.
Rev: a part no: 41866 01.28.09.
