1. DL manuals
  2. Magnum
  3. Stove
  4. SP-40-ZC
  5. Installation And Operation Manual

Magnum SP-40-ZC Installation And Operation Manual

Summary of SP-40-ZC

  • Page 1

    Magnum zc gas installation and operation manual the magnum zc zero clearance wood/gas burning appliance can be adapted for use either with wood or gas. Particular attention needs to be paid to the following guidelines for installation and operation of your magnum zc appliance. ! Installation require...

  • Page 2

    2 installation of the sp-40-zc gas log important: the magnum sp-40-zc gas log kit must be installed by a trained gas technician tools needed: small flat screwdriver - #2 phillips head screwdriver - hammer - punch - gas piping wrenches including pipe cutters, testing equipment and pressure testing eq...

  • Page 3

    3 note: the gas line will have to be located on the left front side of the unit so make sure that you run the line around the bottom of the unit to the front left side with enough length to hook onto the gas valve that will be located in the center front of the unit. There are (3) 1" diameter holes ...

  • Page 4

    4 you can attach the spark igniter to the bracket hand tightening the plastic nut to make sure that it does not get over tightened or stripped. Make sure that the wire for the spark igniter is in place on the back of the spark igniter. Attach the gas line to the inlet of the gas valve. ( this should...

  • Page 5

    6 and attach to the valve. Make sure that all fittings are checked for cracks and leaks. Attach the millivolt wiring as shown in the gas log instruction sheet. Check the gas pressure as shown in the gas log instruction sheet. Pour the sand or vermiculite in the pan and place the logs as shown. Do no...