Magnus DuraPod BX TM-11B Owner's Manual - page 2
Adjusting the Center Column
1
To raise or lower the center column, loosen
the center column locking collar by rotating it
counterclockwise. (Fig. G)
2
Position the center column at the desired height,
and tighten the locking collar by rotating it
clockwise. (Fig. H)
Using the Suction Cup
1
Start with the tripod legs collapsed but in
spread position.
2
Loosen the center column locking collar, and push
the center column downward until the suction cup
adheres to the surface. (Fig. I)
3
Tighten the center column locking collar.
Note: For an enhanced grip, slightly moisten the bottom
of the suction cup.
Using the Universal Ball Head
•
To position the ball head, loosen the ball head
Locking Knob by rotating it counterclockwise.
Position the ball head as required, and tighten ball
head locking knob by rotating it clockwise. (Fig. E)
•
To change the camera orientation from horizontal
to vertical position, loosen the ball head locking
knob. Rotate the ball head 90˚ in either direction,
and tighten the ball head locking knob. (Fig. F)
Figure G
Figure I
Figure F
Figure E
Figure H
Extending the Tripod Legs
1
Spread the tripod legs.
2
Rotate the twist locks a quarter turn
counterclockwise to loosen them. (Fig. A)
3
Pull out the legs to their full extension. (Fig. B)
4
Rotate the twist locks clockwise until secure.
Collapsing the Tripod Legs
1
Rotate the twist locks a quarter turn
counterclockwise to loosen them. (Fig. C)
2
Give each leg a firm push to fully collapse it. (Fig. D)
3
Rotate the twist locks clockwise until secure.
4
Fold the legs in.
Figure A
Figure C
Figure B
Figure D